Answering System Features45Listening to messagesThe base unit display will show the numberof messages (old and new).When new messages have beenrecorded:– the total number will flash.– the ANSWER ON indicator will flashslowly (if the answering system is turnedon).Note:L During playback, the unit will announcethe day and time that each messagewas recorded. (Voice time/day stamp)Using the base unitPress {播放留言}.L The unit will announce the number ofnew messages and will play back thenew messages.L When you have no new messages, theunit will play back all messages.L To stop playback, press {停止}.Note:L The display shows the message numberduring playback.L At the end of the last message, the unitbeeps.To adjust the speaker volume9 levels (off, high to low) are available.Press {V} or {^} repeatedly while usingthe answering system.Repeating a messagePress {<} (<) while listening to themessage.L If pressed within the first 5 seconds of amessage, the previous message will beplayed.Skipping a messagePress {>} (>) to play the next message.Erasing a specific messagePress {删除} while listening to themessage you want to erase.Erasing all messages1 Press { 删除 } while the base unit is notbeing used.L The unit will announce “再按一次删除键,来删除所有留言(To erase allmessages, press ERASE again.)”2 Within 10 seconds, press { 删除 } again.L The unit will announce “没有留言(Nomessages)”.Note:L Caller information for the erasedmessages will remain in the caller list.{PLAY BACK}{ANSWER ON}{STOP}Navigator key({^}, {V},{<}, {>}){ERASE}ENG_TG2871CN.book 45 ページ 2006年5月1日 月曜日 午前11時33分