Programming25Special programmingAlarmAn alarm sounds at the set time for 3minutes once or daily. Alarm can be setfor each handset.Important:L Set the date and time beforehand(page 13).1 {MENU} i {#}{7}{2}{0}2 {V}/{^}: Select the desired alarmoption. i {SELECT}3 Enter the desired month and date.i {OK}4 Set the desired time.5 {AM/PM}: Select “AM” or “PM”. i{OK}6 {V}/{^}: Select the desired alarmtone. i {SELECT}L We recommend selecting adifferent ringer tone from the oneused for outside calls.7 {SELECT} i {OFF}L When the alarm is set, E isdisplayed.Note:L To stop the alarm, press any dial keyor place the handset on the base unitor charger.L When the handset is in use, the alarmwill not sound until the handset is instandby mode.Night modeNight mode allows you to select a periodof time during which the handset will notring for outside calls. This feature isuseful for time periods when you do notwant to be disturbed, for example, whilesleeping. Night mode can be set for eachhandset.Important:L Set the date and time beforehand(page 13).L We recommend turning the base unitringer off (page 15) in addition toturning the night mode on.L If you have set the alarm, the alarmsounds even if the night mode isturned on.Turning night mode on/off1 {MENU} i {#}{2}{3}{8}2 {V}/{^}: Select “On” or “Off”. i{SAVE}L If you select “Off”, press {OFF}to exit.3 Enter the desired hour and minuteyou wish to start this feature.4 {AM/PM}: Select “AM” or “PM”. i{OK}5 Enter the desired hour and minuteyou wish to end this feature.6 {AM/PM}: Select “AM” or “PM”.7 {SAVE} i {OFF}L When the night mode is set, 3 isdisplayed.Note:L To correct a digit, press {<} or {>} tomove the cursor to the digit, thenmake the correction.Changing the start and end time1 {MENU} i {#}{2}{3}{7}Off Turns alarm off. Go tostep 7.Once An alarm sounds once atthe set time.Daily An alarm sounds daily atthe set time. Go to step4.TG403xC(e).book Page 25 Wednesday, January 13, 2010 1:44 PM