Panasonic KX-TG5230 Operating Instructions Manual

Also see for KX-TG5230: Operating instructions

Contents

Panasonic KX-TG5230 Operating Instructions Manual Manual pdf 52 page image

Voice Mail Service52To erase a stored voice mail access numberRepeat steps 1 to 4 on page 51, then press and hold the soft key ( )until all of the digits are erased. Press the soft key ( ), then press[OFF].Setting Voice Mail (VM) Tone DetectionYour telephone company sends special signals (Voice mail tones) to the unit.Press [C], [s] or [SP-PHONE] to listen to the dial tone. If you hear a series of dialtones followed by a continuous dial tone, this indicates that a new message wasrecorded. Voice Mail detection is preset at the factory to ON. Minutes after youhang up or after the phone stops ringing, your unit will seize the phone line andcheck if a message has been recorded. If a new message was recorded at yourtelephone company, ìVoice Mailî will be displayed on the handset, the Ringer/Message Alert indicator on the handset will flash slowly if Message Alert is turnedon (p. 21), and the VM indicator will flash on the base unit.Turn off this programming when:ó you do not subscribe to a voice mail service,ó your telephone company does not send a series of tones, followed by acontinuous tone to indicate you have new voice mail, oró your phone is connected to a business or office telephone system (PBX).See below to turn this setting off.If you are not sure which setting is required, consult your local telephone companyor contact the Panasonic Customer Call Center.1 Press [MENU].2 Scroll to ìInitial settingî by pressing[d] or [B], then press the soft key ( ).3 Press the soft key ( ) at ìVoice Mailî.4 Scroll to ìVM tone detectî by pressing[d] or [B], then press the soft key ( ).5 Select ìOffî or ìOnî by pressing [d] or [B].6 Press the soft key ( ), then press [OFF].CLEARSAVEHandsetSELECT Initial settingSELECTVoice MailSELECT VM tone detectVM tone detect:OnSAVE