Making Calls24To dial after confirming theentered number1. Enter a phone number.• If you misdial, press the soft key( ). Enter the correct phonenumber.• If a pause is required when dialing,press the soft key ( ) whereneeded (p. 56).• To cancel, press [OFF].2. Press [C] or [s].3. To hang up, press [OFF] or placethe handset on the base unit.To adjust the receiver/speaker volume during aconversationThere are 3 volume levels for thereceiver and 6 volume levels for thespeaker.To increase volume, press [B].To decrease volume, press [d].• The display shows the current volumesetting.• If you try to increase/decrease volumewhen it is at the maximum/minimumlevel, the handset will beep 3 times.To redial the last numberdialedPress [C] or [s], then press[REDIAL].To redial using the rediallist (Memory Redial)The last 5 phone numbers dialed arestored in the redial list.1. Press [REDIAL].• The last number dialed is displayed.2. Scroll to the desired number bypressing [d] or [B].• You can also scroll down throughthe list by pressing [REDIAL].• To exit the list, press [OFF].3. Press [C] or [s].• To erase an item, scroll to the itemthen press the soft key ( ).• If “No items stored” is displayed,the list is empty.To put a call on hold1. Press [HOLD/INTERCOM]during a conversation.• “Press extension# totransfer” is displayed.• To transfer the call to the base unitor another handset, see page 46.2. Press [HOLD/INTERCOM]again.• “Hold” is displayed.To return to the call, press [C] or[s].• The base unit user can also take thecall by pressing [SP-PHONE].• Another handset user can also takethe call by pressing [C] or [s].• If another phone is connected on thesame line (p. 11), you can also takethe call by lifting its handset.• If a call is kept on hold for 6 minutes,an alarm tone will start to sound andthe Ringer/Message Alert indicator willstart to flash rapidly. After 4 additionalminutes on hold, the call will bedisconnected.3334444 |CLEARPAUSEVolumeLow HighdBe.g. Receiver volume: HighSpeaker volume: Level 6ERASE