Panasonic KX-TG585SK Operating Instructions Manual

Also see for KX-TG585SK: Operating instructions Operating instructions Quick guide Operating instructions Service manual

Contents

2 MbN: Select the desired group. aMSELECTNR “ ” is displayed next to the selectedgroup numbers.R To cancel the selected group:MbN: Select the group. a PressMSELECTN again. “ ” disappears.3 MSAVEN4 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNBaby monitorThis feature allows you to listen in on a roomwhere another handset is located, allowingyou to easily monitor from different areas ofthe house or place. The monitored handset(placed in a baby’s room, for example) willautomatically call the monitoring handset,base unit, or the phone number stored when itdetects sound.Important:R You should perform a test run of the babymonitor procedure to ensure that the babymonitor feature is set correctly. Forexample, test its sensitivity. Check theconnection if you are diverting the babymonitor to an outside line.R This feature should not be used as asubstitute for a medical or caregiver’ssupervision. It is the caregiver’sresponsibility to stay close enough tohandle any eventuality.Note:R If the unit is connected to a PBX system,you cannot set the baby monitor.R During the monitoring mode, batteryconsumption is faster than usual. Werecommend leaving the monitored handseton the base unit or charger.R The monitored handset never rings while itis being monitored. If the base unit isplaced near the monitored handset, werecommend turning off the base unit ringervolume (page 46, 47).Setting the baby monitorPerform the setting operation with the handsetto be monitored (for example, the handsetplaced in a baby’s room).To monitor with a unitThe internal baby monitor feature is available:– between handsets– between a handset and the base unitHandset1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select the desired unit’s number tomonitor with. a MSAVENR “Baby monitor” will be displayed.R The registered unit’s name/number isdisplayed.Note:R When this feature is on, another handset orthe base unit can hear the monitoredhandset by making an intercom call.To monitor from an outside lineIf you enable this feature, the unit will call apre-programmed phone number when thehandset detects sound. After you answer thecall, you can listen in on the room where thehandset is located.This feature is only available for landline.Handsetn From the phonebook:1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select “Outgoing call” tomonitor from an outside line. aMEDITN a MADDN4 MbN: “Phonebook” a MSELECTN5 MbN: Select the phonebook entry. aMSAVENR “Baby monitor” will be displayed.50 For assistance, please visit http://shop.panasonic.com/supportProgramming