Making/Answering Calls15Making callsUsing the base unit =1 Dial the phone number.L To correct a digit, press ^.2 Lift the corded handset.3 When you finish talking, place the cordedhandset on the cradle.Note:L You can also dial the phone number after liftingthe corded handset.Using the speakerphone1 During a conversation with the cordedhandset, press {s} to turn on thespeakerphone.L You can place the corded handset on thecradle.L Speak into the base unit microphone.L Speak alternately with the other party.2 When you finish talking, press {s}.Note:L For best performance, use the speakerphone ina quiet environment.L To switch to the receiver, lift the corded handset.Using the handset Y1 Lift the handset and dial the phone number.L To correct a digit, press ^.2 {C}3 When you finish talking, press {ih} or placethe handset on the charger.Using the speakerphone1 During a conversation, press {s} to turn onthe speakerphone.L Speak alternately with the other party.2 When you finish talking, press {ih}.Note:L For best performance, use the speakerphone ina quiet environment.L To switch back to the receiver, press {C}.Adjusting the receiver or speakervolumePress {^} or {V} repeatedly while talking.Making a call using the redial listThe last 10 phone numbers dialled are stored inthe redial list in each unit (each 24 digits max.).1 Proceed with the operation for your unit.Base unit: {R}Handset: j (right soft key)2 {V}/{^}: Select the desired phone number.3 Proceed with the operation for your unit.Base unit: Lift the corded handset.Handset: {C}Erasing a number in the redial list1 Proceed with the operation for your unit.Base unit: {R}Handset: j (right soft key)2 {V}/{^}: Select the desired phone number.i 8 i M3 {V}/{^}: “Yes” i M4 Proceed with the operation for your unit.Base unit: {b}Handset: {ih}Pause (for PBX/long distance serviceusers)A pause is sometimes required when making callsusing a PBX or long distance service. Whenstoring a calling card access number and/or PIN inthe phonebook, a pause is also needed (page 19).Example: If you need to dial the line accessnumber “0” when making outside calls with a PBX:1 {0}2 Proceed with the operation for your unit.Base unit: {R}Handset: l3 Dial the phone number.= Base unit / Y Handset= Base unit / Y Handset= Base unit / Y HandsetTG6451_6461FX(e-e).book Page 15 Monday, May 4, 2009 8:55 AM