Panasonic KX-TG6461AL Operating Instructions Manual

Programming25Program this setting using either the base unit orone of the handsets.Important:L When the unit receives a call from a number thatis stored in the call barred list, the call is loggedin the caller list (page 27) with 7 after the call isdisconnected.Storing unwanted callersYou can store up to 30 phone numbers in the callbarred list by using the caller list or by entering thenumbers directly.Important:L It is advised to store the phone number with anarea code in the call barred list.■ From the caller list:1 \ (right soft key)2 {V}/{^}: Select the entry to be barred. i83 {V}/{^}: “Add Bar List” i M4 {EXIT}■ By entering phone numbers:1 8 (middle soft key)2 {V}/{^}: “Caller Barred” i M i~3 Enter the phone number (24 digits max.).i ML To erase a digit, press ^.4 {EXIT}■ From the caller list:1 8 (middle soft key)2 {V}/{^}: “Caller List” i M3 {V}/{^}: Select the entry to be barred. i84 {V}/{^}: “Add Bar List” i M5 {ih}■ By entering phone numbers:1 8 (middle soft key)2 {V}/{^}: “Caller Barred” i M i~3 Enter the phone number (24 digits max.).i ML To erase a digit, press ^.4 {ih}Viewing/editing/erasing bar call numbers1 8 (middle soft key)2 {V}/{^}: “Caller Barred” i M3 {V}/{^}: Select the desired entry.L To exit, press {EXIT}.4 Proceed with the desired operation.■ Editing a number:8 i {V}/{^}: “Edit” i M i Editthe phone number. i M i {EXIT}■ Erasing a number:W i {V}/{^}: “Yes” i M i{EXIT}1 8 (middle soft key)2 {V}/{^}: “Caller Barred” i M3 {V}/{^}: Select the desired entry.L To exit, press {ih}.4 Proceed with the desired operation.■ Editing a number:8 i {V}/{^}: “Edit” i M i Editthe phone number. i M i {ih}■ Erasing a number:W i {V}/{^}: “Yes” i M i{ih}Note for base unit and handset:L When editing, press the desired dial key to add,^ to erase.Registering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to the baseunit.Important:L The additional handset model recommended foruse with this unit is noted on page 4. If anotherhandset model is used, certain operations (base= Base unitY Handset= Base unitY Handset