Programming30 Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333L The next step must be completedwithin 90 seconds.3 Handset:Wait until “Base PIN” is displayed.i Enter the base unit PIN (default:“0000”). i ML If you forget your PIN, see page46.L When the handset has beenregistered successfully, w isdisplayed.Note:L While registering, “Base inregistering” is displayed on allregistered handsets.L When you purchase an additionalhandset, refer to the additionalhandset’s installation manual forregistration.Deregistering a handsetA handset can cancel its ownregistration (or the registration ofanother handset) that is stored to thebase unit. This allows the handset to endits wireless connection with the system.1 8 i {#}{1}{3}{1}L All handsets registered to thebase unit are displayed.2 {V}/{^}: Select the handset youwant to cancel. i M3 {V}/{^}: “Yes” i ML A confirmation tone sounds.L The handset does not beep whencancelling its own registration.4 {ic}Increasing the range of thebase unitYou can increase the signal range of thebase unit by using a DECT repeater.Please use only the Panasonic DECTrepeater noted on page 4. Contact yourPanasonic dealer for details.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.L Do not use more than one repeater ata time.Setting the repeater mode1 8 i {#}{1}{3}{8}2 {V}/{^}: Select the desired setting.i M i {ic}Note:L After turning the repeater mode on oroff, _ is displayed on the handsetmomentarily. This is normal and thehandset can be used once w isdisplayed.TG6561E(e).book Page 30 Tuesday, July 13, 2010 1:50 PM