Panasonic KX-TG6721AL Operating Instructions Manual

Panasonic KX-TG6721AL Operating Instructions Manual Manual pdf 28 page image

7 MbN: Select the desired alarm tone. aR We recommend selecting a differentringer tone from the one used foroutside calls.8 MbN: Select the desired snooze setting.a9 a M NR When the alarm is set, is displayed.Note:R Press to stop the alarm completely.R When the handset is in use, the alarm willnot sound until the handset is in standbymode.R Press any dial key, MSmart functionN, orto stop the sound but keep thesnooze function activated.R If you want to make an outside call whenthe snooze function is activated, pleasestop the snooze function before making thecall.Night modeNight mode allows you to select a period oftime during which the handset will not ring foroutside calls. This feature is useful for timeperiods when you do not want to be disturbed,for example, while sleeping. Night mode canbe set for each handset.Important:R Set the date and time beforehand(page 14).R We recommend turning the base unit ringeroff (page 25) in addition to turning the nightmode on.R If you have set the alarm, the alarm soundseven if the night mode is turned on.Turning night mode on/off1 #2382 MbN: Select the desired setting. aR If you select “Off”, press M N toexit.3 Enter the desired hour and minute youwish to start this feature. aR You can select 24-hour or 12-hourclock format (“AM” or “PM”) bypressing .4 Enter the desired hour and minute youwish to end this feature. a5 M NR When the night mode is set, isdisplayed.Changing the start and end time1 #2372 Continue from step 3, “Turning nightmode on/off”, page 28.Setting the ring delayThis setting allows the handset to ring duringnight mode if the caller waits long enough.After the selected amount of time passes, thehandset rings. If you select “No Ringing”,the handset never rings during night mode.1 #2392 MbN: Select the desired setting. aa M NNote:R When the answering system answers thecall, this feature does not work.Changing the handset nameEach handset can be given a customisedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without entering any handset name,“Handset 1” to “Handset 6” is displayed.1 #1042 Enter the desired name (max. 10characters; page 41).R If not required, go to step 3.328ProgrammingTG672xAL(en)_0125_ver011.pdf 28 2012/01/25 9:16:18