Panasonic KX-TG6811SA Operating Instructions Manual

Advanced new messagealerting featuresAudible message alertThis feature allows the base unit to beep toinform you of a new message arrival whennew messages are recorded. The base unitbeeps 2 times every minute until you listen tothe messages, if the “Base Unit Beep”setting is turned on. The default setting is“Off”.1 M N#3392 MbN: Select the desired setting. a MOKNa MeNNew message alert by a callThis feature allows the unit to make a call tothe pre-stored phone number and inform youthat a new message has been received byannouncement.To use this feature, you must:– store a phone number to which the unitmakes the call to.– turn on the new message alert setting.After you answer the new message alert call,you can listen to messages from that call(page 36).Important:R A new message alert is stopped 1 minuteafter the unit starts to call. The unit will notretry the call even if the call is not answered.Storing a phone number to which theunit makes an alert calln From the phonebook:1 M N#3382 MbN: “Notification to” a MOKNa M N3 MbN: “Phonebook” a MOKN4 MbN: Select the desired phonebookentry. a MOKN a MeNn By entering a phone number:1 M N#3382 MbN: “Notification to” a MOKNa M N3 MbN: “Manual” a MOKN4 Enter the desired name (16 charactersmax.; page 41). a MOKN5 Enter the desired number (24 digitsmax.). a MOKN 2 times a MeNTurning on/off the new message alertsetting1 M N#3382 MbN: “On/Off” a MOKN3 MbN: Select the desired setting. a MOKNa MeNEditing the set phone number1 M N#3382 MbN: “Notification to” a MOKN3 M N a MbN: “Edit” a MOKN4 Edit the name if necessary (16 charactersmax.; page 41). a MOKN5 Edit the phone number if necessary (24digits max.). a MOKN 2 times a MeNErasing the set phone number1 M N#3382 MbN: “Notification to” a MOKN3 M N a MbN: “Erase” a MOKN4 MbN: “Yes” a MOKN a MeNR The new message alert setting isturned off.Activating/inactivating the remoteaccess code to play messagesIf you activate this feature, you must enter theremote access code (page 36) to play thenew message from the new message alertcall. This is so that unauthorised partiescannot listen to your messages. The defaultsetting is “Inactivate”.35Answering SystemTG68xxSA(en)_0619_ver011.pdf 35 2013/06/19 17:43:17