Panasonic KX-TG7100CX Quick Manual

Also see for KX-TG7100CX: Operating instructions

Contents

– 4 –What should I do when thehandset does not turn on?L Make sure that the batteries are installed correctly.L Fully charge the batteries.L Clean the charge contacts and charge again.How long should I charge newbatteries?Charge the batteries for about 7 hours.How long is the battery operatingtime?When you are using fully-charged Ni-MH batteries(included batteries);In continuous use: 17 hours max.In continuous standby mode: 180 hours max.L It is normal for batteries not to reach full capacity at theinitial charge. Maximum battery performance isreached after a few complete cycles of charge/discharge (use).L Actual battery performance depends on a combinationof how often the handset is in use and how often it isnot in use (standby).Can I keep the handset on thebase unit when I am not using it?L Even after the handset is fully charged, the handsetcan be left on the base unit without any ill effect on thebatteries.When should I replace thebatteries?If the batteries are fully charged until 1 is displayed,but 3 is displayed after a few calls, replace thebatteries with new ones.What is a PIN? The PIN is a 4-digit number that must be entered in orderto change certain base unit settings. The default PIN is“0000”.What do I need to do to displaycaller information?L You need to subscribe to Caller ID service. Consultyour service provider/telephone company for details.L The message “You must first subscribe toCaller ID.” will be displayed until you receive callerinformation after subscribing to Caller ID service.Question Cause & solutionTG7100CX(e-e)_QG.fm Page 4 Thursday, May 11, 2006 8:06 PM

/ 6

Related manuals for Panasonic KX-TG7100CX