Useful Information24Error messagesTroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the AC adaptor andturn off the handset, then reconnect the AC adaptor and turn on the handset.TelephoneError message Cause & solutionHukommelse fuld L The handset’s phonebook memory is full. Eraseunnecessary entries (side 14).Man skal abonnere på visnummerL You must subscribe to Caller ID service. Once youreceive caller information after subscribing to Caller IDservice, this message will not be displayed.Problem Cause & solutionw is flashing. L The handset is not registered to the base unit. Register it(side 20).L The handset is too far from the base unit. Move closer.L The AC adaptor is not connected. Check theconnections.L You are using the handset or base unit in an area withhigh electrical interference. Place the handset and baseunit away from interference sources, such as antennasand mobile phones.The handset display is blank. L The handset is not turned on. Turn the power on (side10).The handset will not turn on. L Make sure that the batteries are installed correctly (side9).L Fully charge the batteries (side 9).L Clean the charge contacts and charge again (side 9).I have changed the display language toa language I cannot read.L Change the display language (side 10).TG7100-7102-7103NE(e-da).book Page 24 Wednesday, April 19, 2006 1:09 PM