Programming25Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333Special instructionsfor programmablesettingsAlarmYou can set one of 2 different alarmoptions (once or daily) at a time for eachhandset. An alarm sounds at the set timefor 3 minutes.Important:L Set the date and time beforehand(page 17).1 K (middle soft key)2 {V}/{^}: “Handset Setup” iM3 {V}/{^}: “Time Settings” iM4 {V}/{^}: “Alarm” i M5 {V}/{^}: Select the desired alarmoption. i M6 Set the desired time. i M7 {V}/{^}: Select the desired ringertone. i M 2 timesL We recommend selecting adifferent ringer tone to the oneused for outside calls.L When the alarm is set, E isdisplayed.8 {ih}Note:L You can skip to step 4 by pressing{R/E} in standby mode.L To stop the alarm, press any dial keyor place the handset on the base unitor charger.L When the handset is in use, the alarmwill not sound until the handset is instandby mode.L If you select “Once”, the settingchanges to “Off” after the alarmsounds.L Even when the ringer volume foroutside calls is set to off (page 23), thealarm sound is heard at a low level.Time adjustment (Caller IDsubscribers only)This feature allows the unit toautomatically adjust the date and timeeach time caller information is received.To use this feature, your caller ID servicehas to provide caller information,including date and time. Contact yourservice provider/telephone company fordetails.To turn this feature on, select “CallerID[Auto]”. To turn this feature off,select “Manual”.Important:L To use this feature, set the date andtime first (page 17).1 K (middle soft key)2 {V}/{^}: “Handset Setup” iM3 {V}/{^}: “Time Settings” iM4 {V}/{^}: “Time Adjustment” iM5 {V}/{^}: Select “CallerID[Auto]” or “Manual”. i Mi {ih}“Off”Turns alarm off. Press M again,then press {ih} to exit.“Once”An alarm sounds once at the settime. Enter the desired date andmonth.“Daily”An alarm sounds daily at the set time.TG7301-7321E(e).book Page 25 Thursday, February 14, 2008 9:26 AM