conversation is to be recorded. In case yourecord without informing the other party, itwill cause the infringement of privacy andcivil liability.1 Press during an outside call.2 MbN: “Record Call” aR A beep is heard and recording starts.R A beep sounds every 15 seconds andcan be heard by the other party.3 To stop recording, press .Note:R To listen to the recorded conversation, seepage 43, 44.For AustraliaR All persons using this device for recordingtelephone conversations shall comply withAustralian laws. This requires that at leastone party to the conversation is to be awarethat it is being recorded. In addition, theprinciples enumerated in theAustraliaTelecommunications (Interceptionand Access) Act 1979 shall be compliedwith in respect to the nature of the personalinformation collected, the purpose for itscollection, how it is used and what isdisclosed to any other party.For New ZealandR All persons using this device for recordingtelephone conversations shall comply withNew Zealand law. This requires that atleast one party to the conversation is to beaware that it is being recorded. In addition,the principles enumerated in the PrivacyAct 1993 shall be complied with in respectto the nature of the personal informationcollected, the purpose for its collection, howit is used and what is disclosed to any otherparty.Call shareYou can join an existing outside call.To join the conversation, press M N whenthe other handset is on an outside call.Note:R A 2nd handset cannot join an outside callthat is being recorded (page 17).R To prevent other users from joining yourconversations with outside callers, turn theprivacy mode on (page 28).Key lockThe handset can be locked so that no calls orsettings can be made. Incoming calls can beanswered, but all other functions are disabledwhile key lock is on.To turn key lock on, press for about 3seconds.R is displayed.R To turn key lock off, press for about 3seconds.Note:R Calls to emergency numbers cannot bemade until key lock is turned off.Power back-up operationWhen a power failure occurs, the chargedhandset temporarily supplies power to thebase unit (power back-up mode). This allowsyou to make and receive calls using a handsetduring a power failure. The base unit will notperform any other functions. You can program“Power Failure” and the default setting is“Auto” (page 28).Important:R If a handset is not placed on the base unitwhen a power failure occurs,“Base nopower Press e” is displayed. Afterpressing M N on the handset, place iton the base unit to start power back-upmode.R Power back-up mode will not work if thebattery level of the power supplyinghandset is / .R Do not lift the power supplying handsetfrom the base unit during power back-upmode.R Do not touch the handset’s charge contactsduring power back-up mode.R If the battery level is low, the unit will notwork sufficiently during power back-up18Making/Answering CallsTG8562_8563AZ(en)_0327_ver021.pd18 18 2012/03/27 14:08:06