Useful Information20 For assistance, please visit http://www.panasonic.com/phonehelpTroubleshootingProblem Cause & solutionThe cordless cameradoes not work.L Check the connections (page 8).L The cordless camera is not registered to the base unit.Register the cordless camera to the base unit (page12).The cordless camera’sindicator is flashing red.L The cordless camera is not registered to the base unit.Register the cordless camera to the base unit (page12).L The cordless camera is out of range. Locate thecordless camera near the base unit.The image is faint. L The camera lens is dirty. Clean it with a soft dry cloth.L Do not touch the lens directly. Fingerprint may cause anunclear image.The image sent from thecordless camera is pooron the handset display.L Adjust the display brightness setting (page 15).L Select standard quality mode instead of enhancedmotion mode (page 10).L The place where the cordless camera is located is dark.Improve lighting.The image sent from thecordless camera is darkand difficult to see on thehandset display.L Adjust the display brightness setting (page 15).L There is a strong sunlight or a backlight in the placewhere the cordless camera is located. Try shading thecamera’s location.I cannot connect to thecordless camera, theimage distorts, or theimage is slow.L The cordless camera has lost communications with thebase unit. Move the cordless camera closer to the baseunit, and try again.L There is an obstacle such as concrete wall. Move thecordless camera to the place without an obstacle.L A microwave appliance is in use. Move the cordlesscamera closer to the base unit or use the cordlesscamera away from that appliance, and try again.The camera sensor doesnot respond.L If you set the audio detection sensitivity to off, thecamera sensor does not respond. Turn this feature on(page 16).L While a handset is monitoring the cordless camera, thecordless camera stops detecting sound.