Panasonic KX-TGC210E Operating Instructions Manual

Also see for KX-TGC210E: Operating instructions

Panasonic KX-TGC210E Operating Instructions Manual Manual pdf 27 page image

5 MbN: “Yes” a MOKN a M NOther programmingChanging the handset nameEach handset can be given a customisedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without entering any handset name,“Handset 1” to “Handset 4” is displayed.1 M N#1042 Enter the desired name (10 charactersmax.).3 MOKN4 MbN: Select the desired setting. a MOKN2 times a M NCall restrictionYou can restrict selected handsets fromdialling certain numbers. You can assign up to6 phone numbers to be restricted, and selectwhich handsets are to be restricted. Storingarea codes here prevents the restrictedhandsets from dialling any phone number inthat area code.1 M N#2562 Enter the base unit PIN (default: “0000”).R If you forget your PIN, see page 39.3 Select the handsets to be restricted bypressing 1 to 4.R All handsets registered to the base unitare displayed.R “ ” is displayed next to the selectedhandset numbers.R To cancel a selected handset, pressthe same dial key again. “ ”disappears.4 MOKN5 Select a memory location by pressing 1to 6. a MOKN6 Enter the phone number or area code tobe restricted (8 digits max.). a MOKN aM NChanging the base unit PINImportant:R If you change the PIN (PersonalIdentification Number), please make note ofyour new PIN. The unit will not reveal thePIN to you. If you forget your PIN, seepage 39.1 M N#1322 Enter the current 4-digit base unit PIN(default: “0000”).3 Enter the new 4-digit base unit PIN. aMOKN4 MbN: “Yes” a MOKN a M NIncreasing the range of the baseunitYou can increase the signal range of the baseunit by using a DECT repeater. Please useonly the Panasonic DECT repeater noted onpage 4. Contact your Panasonic dealer fordetails.Important:R Before registering the repeater to this baseunit, you must turn the repeater mode on.R Do not use more than one repeater at atime.Setting the repeater mode1 M N#1382 MbN: Select the desired setting. a MOKNa M NRegistering the DECT repeater(KX-A405) to the base unitNote:R Please use a repeater that has not yet beenregistered to another unit. If the repeater isregistered to another unit, deregister it first,Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333 27ProgrammingTGC21x_22xE_OI_(en-en)_0402_ver.110.pdf 27 2014/04/02 19:29:46