Panasonic KX-TGF372 Operating Instructions Manual

Also see for KX-TG585SK: Operating instructions Operating instructions Quick guide Operating instructions Service manual

Contents

Bluetooth devices out of base unit range, theBluetooth devices are disconnected from thebase unit. This feature allows the base unit totry to reconnect the Bluetooth devices atregular intervals when it returns within baseunit range. You can set the interval. Thedefault setting is “1 min”.Important:R When 3 Bluetooth devices (2 cellularphones and 1 headset) are paired to thebase unit, only 2 Bluetooth devices can beused with the unit at the same time, and thebase unit loses its connection from otherBluetooth devices. To automatically resumethe connection to Bluetooth devices, leavethe auto connection on.R Some cellular phones lose connection afterusage, please check the specifications ofyour cellular phone for more details.Handset1 MMENUN#6322 MbN: Select the desired setting.3 MSAVEN a MOFFNNote:R Some cellular phones may ask you if youaccept the connection requirement from thebase unit. In that case, select “Off” in step2. Check the specifications of your cellularphone.Connecting/disconnecting thecellular phone manuallyIf you will not be using the paired cellularphone’s link to cell feature temporarily (forexample, you do not want the unit to ringwhen your cellular line receives a call), youcan disconnect your cellular phone from thebase unit. If you want to use it again,reconnect the cellular phone to the base unit.Note:R After you disconnect a paired cellularphone from the base unit manually, it willautomatically be connected to the base unitin 30 minutes. If you do not use the link tocell feature anymore, unpair the cellularphone (page 18).R A disconnected cellular phone is notunpaired from the base unit, so pairing it tothe base unit again is unnecessary.Handset1 To connect/disconnect:For CELL 1: MMENUN#6251For CELL 2: MMENUN#6252R A long beep sounds.2 MOFFNCellular line only mode (If you donot use the landline)If you do not use the landline, we recommendsetting the unit to the cellular line only mode.The default setting is “Off”.Important:R If you turn on the “Cell line onlymode”, disconnect the telephone line cordfrom the base unit. Otherwise the “Cellline only mode” cannot be activated.Handset1 MMENUN#1572 To turn on:MbN: “On” a MSELECTN a MbN: “Yes”a MSELECTNTo turn off:MbN: “Off” a MSELECTNNote:R Once you set this mode, you can use thefollowing buttons to make cellular calls:– for the handset, press M N or MZNinstead of MCELLN (page 21).– for the base unit, press MZN withoutpressing MCELL 1N or MCELL 2N set forthe cellular line selection (page 20,27).R Once you set this mode, the followingfeatures cannot be used:– Landline features (page 48)– Answering system (page 62)Messages cannot be received.– Voicemail features (page 69)R After this mode is turned on or off, the baseunit reboots.For assistance, please visit www.panasonic.com/support 19Link to CellTGF37x(en)_1128_ver032.pdf 19 2014/11/28 16:08:39