R To put the outside call on hold:MMENUN a MbN: “Hold” a MOKNTo resume the conference: MMENUNa MbN: “Conference” a MOKNR To cancel the conference: MMENUN aMbN: “Stop Conference” a MOKNYou can continue the conversationwith the outside caller.IntercomIntercom calls can be made betweenhandsets.Note:R When paging the handset, the pagedhandset beeps for 1 minute.R If you receive an outside call while talkingon the intercom, you hear 2 tones. Toanswer the call, press M N, then pressM N.Making an intercom call1 MMENUN (right soft key) a MINTERCOMN2 MbN: Select the desired unit. a MOKN3 When you finish talking, press M N.Answering an intercom call1 Press M N to answer the page.2 When you finish talking, press M N.Using the Smart Function KeyPress M N to answer the page.Turning auto intercom on/offThis feature allows the handset to answerintercom calls automatically when it is called.You do not need to press M N. When thisfeature is set to “On”, the monitoring handsetfor the baby monitor feature (page 33) willalso answer baby monitor calls automatically.The default setting is “Off”.1 MMENUN (right soft key) #2732 MbN: Select the desired setting. a MOKNa M NKey lockThe handset can be locked so that no calls orsettings can be made. Incoming calls can beanswered, but all other functions are disabledwhile key lock is on.To turn key lock on, press MMENUN (right softkey) for about 3 seconds.R To turn key lock off, press M N (right softkey) for about 3 seconds.Note:R Calls to emergency numbers cannot bemade until key lock is turned off.Power back-up operationWhen a power failure occurs, the chargedhandset temporarily supplies power to thebase unit (power back-up mode). This allowsyou to make and receive calls using a handsetduring a power failure. The base unit will notperform any other functions. You can program“Power Failure” and the default setting is“Auto” (page 27).Important:R If a handset is not placed on the base unitwhen a power failure occurs, “Base nopower Press ” is displayed. Afterpressing M N on the handset, place it onthe base unit to start power back-up mode.R Power back-up mode will not work if thebattery level of the power supplyinghandset is / .R Do not lift the power supplying handsetfrom the base unit during power back-upmode.17Making/Answering CallsTGH222_23AZ(en)_0314_ver101.pdf 17 3/14/2014 10:01:16 AM