Registering a handset to a baseunitThe supplied handset and base unit arepre-registered. If for some reason the handsetis not registered to the base unit (for example,is displayed even when the handset isnear the base unit), re-register the handset.1 Handset:MMENUN (right soft key) #1302 MbN: Select a base unit number. a MOKNR This number is used by the handset asa reference only.3 Base unit:Press and hold M N for about 5 seconds.R If all registered handsets start ringing,press M N again to stop, then repeatthis step. (KX-TGH722/KX-TGH723)4 Handset:MOKN a Wait until “Base PIN” isdisplayed. a Enter the base unit PIN(default: “0000”). a MOKNR If you forget your PIN, see page 52.Selecting a base unitWhen “Auto” is selected, the handsetautomatically uses any available base unit it isregistered to. When a specific base unit isselected, the handset makes and receivescalls using that base unit only. If the handset isout of range of that base unit, no calls can bemade.1 MMENUN (right soft key) #1372 MbN: Select the desired base unit number,or “Auto”. a MOKNImportant:R When viewing the phonebook, caller list,etc., only the entries that are stored in thebase unit that the handset is currentlyconnected to are displayed.Deregistering a handsetA handset can cancel its own registration tothe base unit, or other handsets registered tothe same base unit. This allows the handset toend its wireless connection with the system.1 MMENUN (right soft key) #131R All handsets registered to the base unitare displayed.2 MbN: Select the handset you want tocancel. a MOKN3 MbN: “Yes” a MOKN a M NCancelling a base unitA handset can cancel a base unit that it isregistered to. This allows the base unit to endits wireless connection with the system.1 MMENUN (right soft key) #1392 MbN: Select the base unit you want tocancel. a MOKN3 MbN: “Yes” a MOKN a M NIncreasing the range of the baseunitYou can increase the signal range of the baseunit by using a DECT repeater. Please useonly the Panasonic DECT repeater noted onpage 3. Contact your Panasonic dealer fordetails.Important:R Before registering the repeater to this baseunit, you must turn the repeater mode on.R Do not use more than one repeater at atime.Setting the repeater mode1 MMENUN (right soft key) #1382 MbN: Select the desired setting. a MOKNa M NRegistering the DECT repeater(KX-A405/KX-A406) to the base unitNote:R Please use a repeater that has not yet beenregistered to another unit. If the repeater isregistered to another unit, deregister it first,referring to the Installation Guide for theDECT repeater.38 Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333Programming