[D]/[C]: "Ringer Volume"aOK3. [D]/[C]: Select the desired setting. aOK *1*1 When using a KX-TPA65/KX-TPA68, the volume can also be adjusted by using /[VOL].NoteR You can press the [D] key instead of performing steps 1 and 2.R For details about setting the ringer pattern, see “Incoming Option”, Page 107.Adjusting the Ringer Volume or Turning the Ringer Off while RingingWhile receiving a call, do the following to adjust the ringer volume or turn the ringer off:NoteR If you attach a headset while receiving an incoming call, the ring from the handset does not switch tothe headset. If you attach a headset before receiving an incoming call, and headset ringer is set to"On", ringing will be heard from the headset.To adjust the ringer volume1. [D]/[C]: Adjust the volume.*12. KX-TPA60:, / /[XFER/CLR]: ExitKX-TPA65/KX-TPA68:/[CANCEL], / /[TRANSFER/CLEAR]: Exit*1 The adjusted volume level will also be used for subsequent calls.When using a KX-TPA65/KX-TPA68, the volume can also be adjusted by using /[VOL].To turn the ringer off1.Incoming/Outgoing Call LogWhen connecting the desk phone and handset in parallel, the Incoming/Outgoing Call Log is sharedbetween the desk phone and handset. For details about parallel connection settings, see “Parallel Mode(KX-TPA65/KX-TPA68)”, Page 52.Displaying the Incoming Call Log[In standby mode]1. [F]2. [D]/[C]: "Incoming Log" aOK *1*1 If "Missed Calls" is not displayed on the LCD in standby mode, this step can be skipped.When connected to a base unit other than the KX-TGP600, since "Incoming Log" is not displayed,select from "Missed Call"/"Answered Call".NoteR For details about the other operations, see “Screen Transition Diagram”, Page 48.Displaying the Outgoing Call Log[In standby mode]1. [C]*1*1 You can also press / .51Before Operating the Telephones