1 Getting Started1-A Location of controls4 Things You Should Know1-B Settings4-A Wall Mounting4-B Troubleshooting2ABC 3DEF15JKL 6MNO4GHI8TUV 9WXYZ7PQRS0R(R) Button (3-A)RINGER Selector(1-B)Button (2-A)VOLUME (^), (_)Buttons (2-A)1 Connect the telephone line cord (1).2 Connect the handset cord (2), then confirmthe dial tone.≥Use only a telephone line cord included in theunit.To Single-Line Telephone JackHandset CordHandsetTelephone Line CordRINGER Selector121 When the unit rings, lift the handset.2 When finished talking, hang up.HIGH OFFRINGER3 Set the RINGER selector to HIGH, LOW orOFF.(Ex. “LOW” is selected.)2-A Making Calls2-B Answering Calls1 Lift the handset.2 Dial a phone number.≥If you misdial, hang up and start again fromstep 1.3 When finished talking, hang up.To redial the last number dialedLift the handset. ➡ Press .To adjust the receiver volume (6 levels)while talkingTo increase, press (^).To decrease, press (_).≥After hanging up, the volume level will be saved.(\\\)2 Operation 3 Special Features3-A For Call Waiting Service UsersPress (R) if you hear a call-waiting tone whiletalking.≥The first call is put on hold and you can answer thesecond call.≥To return to the first caller, press (R) again.To temporarily set thehandset down duringa conversation, placeit as shown here.The unit can be mounted on a wall.1 Press the tabs in the direction of the arrows(1), then remove the wall mounting adaptor(2).To Single-LineTelephone JackScrews8.3 cmHooks ProblemThe unit does notwork.The call cannot beconnected even ifyou dialedcorrectly.The unit does notring.Remedy≥Check the settings (1-B).≥Check the settings (1-B).≥The RINGER selector isset to OFF. Set to HIGHor LOW (1-B).8.3 cmWall TemplateTake special care to follow the safety suggestionslisted below.InstallationsEnvironment1) Do not use this unit near water—for example,near a bathtub, washbowl, sink, etc. Dampbasements should also be avoided.2) The unit should be kept away from heat sourcessuch as radiators, kitchen range, etc. It alsoshould not be placed in rooms where thetemperature is less than 5oC or greater than 40oC.Placement1) Do not place heavy objects on top of this unit.2) Care should be taken so that objects do not fallonto, and liquids are not spilled into the unit. Donot subject this unit to excessive smoke, dust,mechanical vibration or shock.3) Place the unit on a flat surface.WARNING:TO PREVENT FIRE OR SHOCK HAZARD, DONOT EXPOSE THIS PRODUCT TO RAIN OR ANYTYPE OF MOISTURE.PQQX13904ZA F0803-0 DManufactured by PanasonicCommunications (Malaysia) Sdn. Bhd.Senai MalaysiaIf trouble occurs, disconnect the unit from thetelephone line and connect to a known workingphone. If the known working phone operatesproperly, do not reconnect the unit until the troublehas been repaired. If the known working phonedoes not operate properly, consult your telephonecompany.For your future referenceSerial No.(found on the bottom of the unit)Date of purchaseName and address of dealerIntegrated Telephone SystemOperating InstructionsModel No. KX-TS500EXPLEASE READ BEFORE USE AND SAVE. ∑ Handset. . . . . . . one∑ Handset Cord. . . one∑ Telephone Line Cord. . . . . . . . . . . . . oneAccessories (included)4-C Safety Instructions≥When set to OFF, the unit will not ring.3 Install screws using the wall templatebelow. Connect the telephone line cord.Mount the unit, then slide down.≥Fasten the cord to prevent it from beingdisconnected.1122 Tuck the telephone line cord inside the wallmounting adaptor, and push it in thedirection of the arrow (1 and 2).≥The word “UP WALL” should face upward.12KX-TS500EXW4-D SpecificationsPower Source: From telephone lineDimensions (H x W x D):Approx. 96 mm x 150 mm x 200 mmMass (Weight): Approx. 475 gDialing Mode: Tone (DTMF)Operating Environment: 5°C–40°CSpecifications are subject to change without notice.This equipment is designed for use in Italy, Spain,Greece, Netherlands and France.In the event of problems, you should contact yourequipment supplier in the first instance.We, Panasonic Communications Co., Ltd. declarethat this equipment is in compliance with theessential requirements and other relevant provisionsof Directive 1999/5/EC.If you want to get a copy of the original Declarationof Conformity of our products which relates to theR&TTE, please contact to our web address:http://doc.panasonic-tc.de1999/5/EC