Panasonic KX-TS520FX Operating Instructions Manual

Also see for KX-TS520FX: User manual

1-62, 4-chome, Minoshima, Hakata-ku,Fukuoka 812-8531, Japan5 Things You Should Know1-A Controls5-B Troubleshooting1 Press the tabs in the direction of the arrows(), then remove the wall mounting adaptor().To temporarily set thehandset down during aconversation, place it asshown here.8.3 cmWall TemplatePNQX1358ZA FM0908YS0For your future referenceWe recommend keeping a record of the followinginformation to assist with any repair under warranty.Serial No.(found on the bottom of the unit)Date of purchaseName and address of dealerOperating InstructionsIntegrated Telephone SystemModel No. KX-TS520FXPlease read these operating instructions beforeusing the unit and save them for future reference.Accessory information Handset . . . . . . . . . . . . . . . . . one Handset cord . . . . . . . . . . . . . one Telephone line cord . . . . . . . . one5-C For your safety2 Tuck the telephone line cord inside thewall mounting adaptor, and push it in thedirection of the arrow. The word “UP WALL” should face upward.1 Getting Started1-B ConnectionsM1FLASHPROGRAMPAUSEABCDEFJKLGHI12 34567890MNOTUVPQRSWXYZTONEREDIALM2M3M1M2M3VOLUMEM1M2M3   1 Lift the handset and dial the phone number .2 When you fi nish talking, place the handseton the cradle.To redial the last number dialedLift the handset  Press {REDIAL}. {REDIAL} will dial the last number you calledmanually, not a One-Touch Dialer number (3-B).To adjust the receiver volume (6 levels)Press {} or {} repeatedly while talking. After hanging up, the volume level will be saved.When a call is being received, the unit rings,the ringer indicator flashes quickly. You cananswer the call by simply lifting the handset.2-B Answering callsYou can store up to 3 phone numbers in theone-touch auto dial buttons {M1}, {M2} or {M3}.Do not press any one-touch auto dial buttonsbefore storing to prevent misoperation.1 Lift the handset  Press {PROGRAM}.2 Press the one-touch auto dial button {M1},{M2} or {M3}.3 Enter a phone number up to 21 digits.4 Press {PROGRAM}.5 When finished, hang up. If a pause is required for dialing, press{PAUSE} in step 3. A pause stored in a phonenumber counts as one digit (4-C).3-B Dialing a stored number1 Lift the handset.2 Press the one-touch auto dial button {M1}, {M2} or {M3}. {REDIAL} does not work for One-Touch Dialer.To dial the number again, hang up and repeat steps 1 and 2. If the telephone line cord is disconnected more than 3 days, the stored numbers may be erased.Store phone numbers again, if necessary.If you misprogramHang up  Restart from step 1.To erase a stored numberLift the handset  Press {PROGRAM}  the one-touch auto dial button {M1}, {M2}or {M3} of the phone number to be erased  {PAUSE}  {PROGRAM}  Hang up.Memory stickerUse the memory sticker as a name or phonenumber index for the stored numbers.4 Special Features2-A Making calls 5-A Wall mounting3 Drive screws (not included) into the wallusing the wall template below. Connect thetelephone line cord. Mount the unit and thenslide it down.4-A For call waiting service users4-B Temporary tone dialing (for rotary/pulse service users)To use call waiting, you must first subscribe to the call waiting service of your service provider/telephone company. This feature allows you to receive calls while you are already talking on thephone. If you receive a call while on the phone, you will hear a call waiting tone.1 Press {FLASH} to answer the 2nd call.2 To switch between calls, press {FLASH}.Note: Please contact your service provider/telephone company for details and availability of this service in yourarea.You can temporarily switch the dialing mode to tone when you need to access touch-toneservices (for example, answering services, telephone banking services, etc.). Press {*} {TONE}before entering access numbers which require tone dialing.4-C Pause (for PBX/long distance service users)A pause is sometimes required when making calls using a PBX or long distance service.Example: If you need to dial the line access number “9” when making outside calls with a PBX:1 Lift the handset to start calling.2 {9}  {PAUSE}3 Dial the phone number.Note: A 2.1 second pause is inserted each time {PAUSE} is pressed. Repeat as needed to create longerpauses.3-A Storing phone numbers in memoryProblem Cause/solutionThe unit does not work.  Check the connections (1-B).The call cannot be connectedeven if you dialed correctly. Check whether the DIALING MODE selector setting is correct or not(1-B).The unit does not ring.  The RINGER selector is set to OFF. Set to HIGH or LOW (1-B).You cannot store a phonenumber in memory. Confirm the handset is off the cradle. Do not enter a phone number more than 21 digits long, or theentered number and the previously stored number will be cleared.The other party suddenlycannot hear your voice duringa conversation. {PROGRAM} was pressed during the conversation. Press{PROGRAM} again.You cannot redial by pressing{REDIAL}. If the last number dialed was more than 31 digits long, the numberwill not be redialed correctly.Liquid or other form ofmoisture has entered the unit. Disconnect the telephone line cord from the unit. Leave to dry forat least 3 days. After the unit are completely dry, reconnect thetelephone line cord.M1M2M35 Things You Should Know The ringer indicator will flash when a telephone number is dialed in PULSE mode,or someone picks up or hangs up another phoneconnected to the same phone line.This is normal.2 Making/Answering Calls 3 One-Touch Dialer3 One-Touch DialerAttach your purchase receipt here. Memory sticker  DIALING MODEselector Ringer indicator  RINGER selector Auto dial {M1},{M2}, {M3} {REDIAL} VOLUME {},{} {FLASH} {PAUSE}  {PROGRAM} {*} {TONE}1 Connect the handset cord () to the handsetand the unit. Connect the telephone linecord until it clicks into the unit and telephoneline jack (). After line connection, lift thehandset to check for a dial tone.2 Set the DIALING MODE selector to TONE. If you cannot dial,set to PULSE.DIALING MODEPULSETONE3 Set the RINGER selector to HIGH, LOW or OFF.(Example : “HIGH” is selected.) When set to OFF, the unitwill not ring but the ringerindicator will still fl ashing. OFFHIGH LOWRINGERConnecting a communication deviceIf you connect a communication device (computer, modem, fax, answering machine, etc.) tothe telephone line, you can connect it through this unit using the DATA jack. After connectingthe handset and telephone line cord, connect the communication device telephone line cord tothe DATA jack. Make sure the communication device is not in use before using this unit (making calls, storing phonenumbers in memory etc.) or the communication device may not operate properly.M3M3M2M2M1M1To single-linetelephone jackTelephoneline cordHandsetHandset cordLINE DATATo prevent severe injury and lost of life/property, read this section carefully beforeusing the product to ensure proper and safeoperation of your product.WARNING To prevent the risk of fire or electrical shock, donot expose the product to rain or any type ofmoisture. Do not disassemble the product. Do not spill liquids (detergents, cleansers, etc.)onto the telephone line cord plug, or allow itto become wet at all. This may cause a fire.If the telephone line cord plug becomes wet,immediately pull it from the telephone wall jack,and do not use.CAUTION Never install telephone wiring during an electricalstorm. Never install telephone line jacks in wet locationsunless the jack is specifically designed for wetlocations. Never touch uninsulated telephone wires orterminals unless the telephone line has beendisconnected at the network interface. Use caution when installing or modifyingtelephone lines.Important safety instructionsWhen using your product, basic safety precautionsshould always be followed to reduce the risk of fire,electric shock and injury to persons, including thefollowing :Do not use this product near water, for example,near bathtub, washbowl, kitchen sink or laundrytub, in a wet basement or near a swimming pool.1.Avoid using a telephone (other than a cordlesstype) during an electrical storm. There may be aremote risk of electric shock from lightning.Do not use the telephone to report a gas leak inthe vicinity of the leak.SAVE THESE INSTRUCTIONSEnvironment The product should be kept free from excessivesmoke, dust, high temperature, and vibration. The product should not be exposed to directsunlight. Do not place heavy objects on top of the product. The product should be kept away from heatsources such as radiators, cookers, etc. It shouldnot be placed in rooms where the temperatureis less than 5°C or greater than 40°C. Dampbasement should also be avoided.Routine care Wipe the outer surface of the product with asoft moist cloth. Do not use benzine, thinner, or any abrasivepowder.Notice for product disposal, transfer, orreturn This product can store your private/confidentialinformation. To protect your privacy/confidentiality,we recommend that you erase the informationsuch as one-touch dialer from the memory beforeyou dispose of, transfer, or return the product.2.3.Screws8.3 cmTo single-linetelephone jack(LINE)HooksTo communicationdevice (DATA)DATALINEPower Source: From telephone lineDimensions (H x W x D): Approx. 95 mm  190 mm  196 mmMass (Weight): Approx. 518 gOperating conditions: 5°C–40°C, 20 %–80 % relative air humidity (dry)Note: Design and specifications are subject to change without notice. The illustrations in these instructions may vary slightly from the actual product.5-D Specifications5 Things You Should KnowNote: This equipment is designed for use in CzechRepublic, Slovakia and Turkey. In the event of problems, you should contact yourequipment supplier in the fi rst instance.Declaration of Conformity: Panasonic Communication Co., Ltd. declares thatthis equipment is in compliance with the essentialrequirements and other relevant provisions ofRadio & Telecommunications Terminal Equipment(R&TTE) Directive 1999/5/EC. Declarations ofConformity for the relevant Panasonic productsdescribed in this manual are available fordownload by visiting:http://www.doc.panasonic.deContact to Authorised Representative:Panasonic Testing CentrePanasonic Marketing Europe GmbHWinsbergring 15, 22525 Hamburg, GermanyCopyright:This material is copyrighted by PanasonicCommunications (Malaysia) Sdn. Bhd., andmay be reproduced for internal use only.All other reproduction, in whole or in part,is prohibited without the written consent ofPanasonic Communications (Malaysia) Sdn.Bhd.© 2008 Panasonic Communications(Malaysia) Sdn. Bhd. All Rights Reserved .M1M2M3M1M2M3PNQX1358ZA.indd 1PNQX1358ZA.indd 1 11/11/2008 5:20:57 PM11/11/2008 5:20:57 PM

/ 2

Related manuals for Panasonic KX-TS520FX