4.6 KX-TA Series PBX Programming for APT IntegrationInstallation Manual 1214.6 KX-TA Series PBX Programming for APTIntegrationFor KX-TA824 programming via the Operating and Maintenance Tool, refer to 4.3 KX-TA824 PBXProgramming for APT Integration.For KX-TA1232 programming, refer to 4.4 KX-TD Series PBX Programming for DPT Integration.Programming procedures and availability may vary by PBX model, software version, etc. Referto the documentation included with the PBX or consult your dealer for more information.Note• The KX-TA824 can also be programmed via PC using the Operating and Maintenance Tool.Refer to 4.3 KX-TA824 PBX Programming for APT Integration.• For KX-TA824, PBX software version 1.0.44 or later is required for APT Integration. Consultyour dealer for more information.It is important that the PBX has the proper software level to allow APT Integration with the VPS.Follow the procedures below to confirm the software level, then complete the required programmingbefore starting up the VPS.All of the following procedures must be completed after entering system programming. Referto the KX-TA series Installation Manual for instructions on how to enter the systemprogramming mode.1. Using the Manager Extension, check the software version of the KX-TA series PBX using SystemProgram [998].Example: Y581J000421(XX)The underlined digits represent the software production date code (year, month, day). For APTIntegration, the production date must be 000421 or later.If the software version of the PBX is lower than this, consult your dealer.From the SYS-PGM NO ? screen:a) Enter [998].b) Press the NEXT button (SP-PHONE). The PBX displays the ROM version and the date itwas created.2. Set the date and time using System Program [000].Date and time are automatically synchronized between the VPS and the PBX during QuickSetup.3. Set extension numbering using System Program [009].4. Assign the voice mail port. This program tells the PBX which jacks will be connected to the VPS.This allows the PBX to send the proper APT Integration information to those ports. Jack 07, orjacks 07 and 08 can be assigned for the VPS1 as the voice mail port. Jack 15, or jacks 15 and16 can be assigned for the VPS2.
