5.2 PBX Settings for Inband Integration132 Installation Manual5.2.3 PBX Interface ParametersThe following items can be programmed using KX-TVA Maintenance Console under "SystemParameters" by selecting the "Parameters" tab.PBX Environment• PBX TypeSpecifies the type of PBX which is connected to the VPS.• Integration ModeSelect "Inband". If PBX type is set to the Panasonic KX-T series, the Inband Signalingparameters are set automatically and should not be altered.SEQUENCE CODES• Maximum Extension Number LengthSpecifies the maximum number of digits that the connected PBX recognizes as an extensionnumber.• Extension Number of VPS PortSpecifies the extension number for each VPS port on the connected PBX.Note• Extension numbers of the VPS ports will automatically be assigned when the PBX type hasbeen changed.• Operator Transfer SequenceTells the VPS how to transfer a call to the operator.Example: FTX [hookswitch flash dial tone dial (operator) extn.]• Extension Transfer SequenceTells the VPS how to transfer a call to an extension.Example: FTX [hookswitch flash dial tone dial extn.]• Alternate Extension Transfer SequenceTells the VPS how to transfer a call to an extension that belongs to the "Alternate ExtensionGroup". This is useful for extensions that need a special transfer procedure (i.e., blind transfer)such as modem extensions.Example: FTXD [hookswitch flash dial tone dial extn. hang up]D DisconnectF Hookswitch FlashR Ring DetectionT Dial Tone DetectionX Dial Extension, Dialing Pause (default 1 s); Dialing Pause (default 3 s)0-9, , # DTMF Tones
