Panasonic KX-UT113 Operating Instructions Manual

Also see for KX-UT113: Configuration guides User guide Operating instructions Administrator's guide Administration guide

Contents

Panasonic KX-UT113 Operating Instructions Manual Manual pdf 29 page image

Receiving CallsThis section explains the basic methods for receiving acall.Receiving a Call1. Go off-hook.2. To end the call, go on-hook.Auto answerYou can have the unit automatically answer anincoming call. The call is connected after a programmednumber of rings.• To enable Auto Answer:In stand-by mode, press [AUTO ANSWER/ ] until"Auto Answer On" appears.• To disable Auto Answer:In stand-by mode, press [AUTO ANSWER/ ] until"Auto Answer Off" appears.Note• When Auto Answer is enabled,AUTO ANSappears on the display in stand-by mode.Rejecting CallsYou can reject an incoming call at your unit or set theunit to reject certain calls.Rejecting a call while receiving1. When receiving an incoming call, pressReject .Rejecting anonymous callsYou can set the unit to reject calls when the unitreceives a call without phone number.To reject anonymous calls, the Block Anonymous Callsetting must be enabled through Web user interfaceprogramming (Page 58). For details, consult youradministrator or dealer.Note• Rejected phone numbers will not be stored inthe incoming call log.• Depending on the line an incoming call isarriving on, the call may not be rejected.Rejecting specific callsYou can set the unit to reject specific phone numbers.Note• Rejected phone numbers will not be stored inthe incoming call log.Adding a phone numberYou can store a maximum of 30 phone numbers youwant to reject in the rejection list of the unit.1. In stand-by mode, pressSetting .2. Press [ ] or [ ] to select "Call Block", and thenpress [ENTER].3. PressAdd .4. Enter the telephone number (max. 32 digits), andthen press [ENTER].Note• To register additional telephone numbers,repeat the procedure from step 3.Adding a phone number from the incoming calllogYou can add a phone number by referring to theincoming call log.1. In stand-by mode, pressCall Log .2. Press [ ] or [ ] to select "Incoming Call Log",and then press [ENTER].3. Press [ ] or [ ] to select the entry with the phonenumber you want to reject.4. PressSave .5. Press [ ] or [ ] to select "Call Block", and thenpress [ENTER].6. Press [ ] or [ ] to select "Yes", and then press[ENTER].Note• If you do not press any buttons for 1 minute, theunit will return to stand-by mode.Editing a stored phone number1. In stand-by mode, pressSetting .2. Press [ ] or [ ] to select "Call Block", and thenpress [ENTER].3. Press [ ] or [ ] to select the phone number youwant to edit, and then pressEdit .4. Edit the phone number as necessary, and thenpress [ENTER].Document Version 2011-09 Operating Instructions 29Feature Operations