Panasonic LC2H preset Specifications

Also see for LC2H preset: Manual Manual Instructions

Contents

LC2H114OptionsFor LC2H total counter(installation frame type)(1) Remove the battery cover from thecase.(2) Remove the battery from the side ofthe case. The battery will comeloose if you put the battery side facedown and lightly shake the unit.(3) Before inserting wipe clean thesurface of the new battery.(4) Insert the new battery with the “+”and “–” sides in the proper position.(5) After replacing the battery, returnthe battery cover to the case. Verifythat the hook of the battery cover isproperly engaged.(6) Before using press the reset buttonon the front.6. Terminal connectionTighten the terminal screws with a torqueof 0.8 N·cm or less.1“−” side“+” side2651. Accessories (for LC2H totalcounter)Panel cover (black)Part No.: AEL3801You can change the design of the frontpanel by replacing it with this black panelcover. The counter comes with an ashgray panel cover as standard.Note: No panel cover accessory (black) is availablefor the LC2H preset counter.2. Lithium battery (3 V)Part No.: ATH3802Packaged with the LC2H (excluding thePC board mounting type).3. Installation partsMounting frame(Suitable for installation frame type LC2Htotal counter and LC2H preset counter)Part No.: ATH3803Packaged with the mounting bracket typeLC2H total counterRubber gasket(Suitable for installation bracket typeLC2H total counter and LC2H presetcounter)Part No.: ATH3804Packaged with the mounting bracket typeLC2H total counterRESETCOUNTERLC2HPanasonicCR24773VJAPANWarning• Make sure the “+” and “−” polarities arepositioned correctly.• Do not throw the old battery into a fire,short circuit it, take it apart, or allow it tocome into contact with heat.• The battery is not rechargeable.CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net