Connecting to other equipment- 188 -Connect the camera to a PC via the USB connection cable A(supplied).• Do not use any other USB connection cables except the supplied one.Use of cables other than the supplied USB connection cable may cause malfunction.Using a drag-and-drop operation, move the pictures you want toacquire or the folder storing those pictures to any different folder onthe PC.∫ Disconnecting the USB connection cable safely• Proceed with the hardware removal using “Safely Remove Hardware” on the task tray of thePC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCD monitor ofthe digital camera before removing the hardware.Note• This unit cannot stand upright when the AC adaptor is connected. When placing it on a surfaceand operating it, we recommend placing it on a soft cloth.• Turn the camera off before connecting or disconnecting the AC adaptor (optional).• Before inserting or removing a card, turn the camera off and disconnect the USB connectioncable. Otherwise, data may be destroyed.Press 3/4 to select [PC], and then press [MENU/SET].• If [USB MODE] (P37) is set to [PC] in the [SETUP] menu inadvance, the camera will be automatically connected to the PCwithout displaying the [USB MODE] selection screen. Sincethere is no need to set this each time you connect to the PC, itis convenient.• When the camera has been connected to the PC with[USB MODE] set to [PictBridge(PTP)], a message may appearon the PC’s screen. Select [Cancel] to close the screen, anddisconnect the camera from the PC. Then set [USB MODE] to[PC] again.Double-click on [Removable Disk] in [My Computer].• When using a Macintosh, the drive is displayed on the desktop. (“LUMIX”, “NO_NAME”or “Untitled” is displayed.)Double-click [DCIM] folder.USB MODEPLEASE SELECTTHE USB MODESELECT SETPictBridge(PTP)PC
