Panasonic Lumix DMC-LZ7P Service Manual

15About "*" indication in the above table:The third digit from the left is different as follows.- In case of 0 (example: 18001000)When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has beencompleted.It means that this error is occurred basically at user side.- In case of 8 (example: 18801000)When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has beenreleased.(Example; Factory assembling-line before unit shipment, Service mode etc.)It means that this error is occurred at service side.• 6. How to returned to Normal Display:Turn the power off and on, to exit from Error code display mode.NOTE:The error code can not be initialized.HARD VENUS A/D Flash 20*0 0000 Flash charging error.IC6001-(247) signal line or Flash charging circuitFLASH ROM(EEPROMArea)FLASH ROM(EEPROMArea)2B*0 0001 EEPROM read errorIC6002 (FLASH ROM)0002 EEPROM write errorIC6002 (FLASH ROM)SYSTEM RTC 2C*0 0001 SYSTEM IC initialize failure errorCommunication between IC6001 (VENUS 3) and IC9101 (SYSTEM)SOFT CPU Reset 30*0 0001|0007NMI resetNon Mask-able Interrupt(30000001-30000007 are caused by factors)Card Card 31*0 0001 Card logic errorSD memory card data line or IC6001 (VENUS 3)0002 Card physical errorSD memory card data line or IC6001 (VENUS 3)0004 Write errorSD memory card data line or IC6001 (VENUS 3)39*0 0005 Format errorCPU,ASIC hardStop 38*0 0001 Camera task finish process time out.Communication between Lens system and IC6001 (VENUS 3)0002 Camera task invalid code error.IC6001 (VENUS 3)0100 File time out error in recording motion imageIC6001 (VENUS 3)0200 File data send error in recording motion imageIC6001 (VENUS 3)0300 Single or burst recording brake time out.Operation Power on 3B*0 0000 FLASHROM processing early period of camera during movement.Zoom Zoom 3C*0 0000 Inperfect zoom lens processing.Zoom lens35*0 0001|0007Software error.(0-7bit : command, 8-15bit : status)35*1 0000 Though record preprocessing is necessary, it is not called.35*2 0000 Though record preprocessing is necessary, it is not completed.3C*0 0000 Inperfect zoom lens processing.Attribute Main item Sub item Error code Contents (Upper)High 4 bits Low 4 bits Check point (Lower)