VQT1P79 81VQT1P79 81Connectingwith otherdevices 1 Using with your PCConnect the camera to your computer to save, play,print, and e-mail your pictures.Set-up:• Connect the camera to the AC adaptor (DMW-AC5PP, sold separately). (Alternatively, use asufficiently-charged battery.)• Card :Insert card and set mode dial toany exceptBuilt-in memory :Remove cardTo cancel connection Click ‘Safely Remove Hardware’ in the WindowsSystem Tray → disconnect USB connection cable →turn off camera power → disconnect AC adaptorDo not use any other USB connection cables except the supplied one.Turn off power before inserting or removing memory cards.If using Windows 98/98SE, install USB driver software when connecting for first time.When the battery begins to run out during communication, the status indicator flashesand a warning beep sounds. Cancel communication via your computer immediately(recharge the battery before reconnecting).Setting the ‘USB MODE’ (P.25) to ‘PC’ remove the need to make the setting each timethe camera is connected to the computer.For more details, consult your computer operating manual.1 Turn on power ofboth camera andcomputer2 Set REC/PLAYswitch to3 Connect camera tocomputer4 Select ‘PC’ on thecameraPictBridge(PTP)PCPLEASE SELECTTHE USB MODEUSB MODESETSELECT(A message may be displayedon screen if ‘USB MODE’ (P.25)is set to ‘PictBridge (PTP)’.Select ‘CANCEL’ to close thescreen, and set ‘USB MODE’to ‘PC’.)5 Operate with yourcomputer (see nextpage)Check socket directionand insert straight in.(Damage to socketshape can lead tofaulty operation.)ACCESS(sending data)• Do not disconnect the USBconnection cable while‘ACCESS’ is displayed.USB connection cable• always use cablesuppliedHold hereIf using AC adaptor, turnoff camera power beforeplugging in or removing.Downloaded From camera-usermanual.com Panasonic Manuals