Panasonic MC-CG902-00 Service Manual

Contents

8. Reroute all wiring per original layout utilizing wire retainersprovided, and proper placement of wires to preventpinching of wires and interference when reinstalling theindicator block assembly. Connect wires and apply wirenuts, (reference WIRING DIAGRAM & DRAWING).9. Install indicator block assembly. Holding the assembly at aslight angle, insert the edge of the part behind the retainingtabs (use T-shaped tab on assembly to align in slot ofretaining tab). With fingers lifting base off the floor (to freefront axle) use both thumbs to push the indicator blockassembly down until it snaps in place.10. Install the overload protector by snapping into positionbetween the two retaining tabs and with one end pushed upagainst the indicator block assembly.11. Replace remaining parts (see BELT REMOVAL).3.4. AGITATOR ASSEMBLY3.4.1. Agitator Checking1. When brushes are worn to the level of the base supportbars, replace the agitator.3.4.2. Agitator Assembly Replacement1. Remove Power Nozzle cover, agitator cover, belt andagitator assembly (see BELT REMOVAL).2. Reassemble belt, agitator assembly, Power Nozzle cover,light bulb and light cover (see BELT REPLACEMENT).13MC-CG902-00

/ 15

Related manuals for Panasonic MC-CG902-00