4.1. HOOD4.1.1. Removal1. Lift up on the hood release as the hood is raised.2. With the hood all the way up, force it until the two ends popout of place.4.1.2. Replacement1. Place each end of the hood into the slot while holdingupright in the position it was removed.2. Work both ends into the openings and close.4.2. CANOPY COVER4.2.1. Removal1. Remove the cord rewind bar by snapping it off from rear tofront.2. The canopy cover has a screw on each of the four (4)corners securing it in place. Use a screwdriver to removeeach screw.3. Lift the canopy cover off of the canister base.4. Secure the power cord to prevent retracting as you areservicing the motor.4.2.2. Replacement1. Set the canopy cover in position and secure the canopywith (4) screw holes.2. Snap the cord rewind bar into place on the canopy cover.4.3. CORD REEL4.3.1. Removal1. Remove hood (see HOOD Removal).2. Remove canopy cover (see CANOPY COVER Removal).3. Disconnect both cord reel wires.4. Remove the cord cover cap from the base.5. Lift the cord reel straight up to remove. Do this by prying itout of the retainers.4.3.2. Replacement1. Connect both wire cord reel wires to the new cord reelassembly.2. Route the plug through the hole in the canister base andsnap the cord cover cap in place.3. Position the slots in the cord reel brackets into place overthe retainers in the base.4. Route the cord reel wire into the provided slot to preventpinching5. Replace canopy cover and brake pedal (see Canopy CoverReplacement.6. Replace hood (see Hood Replacement).4.4. CANISTER MOTOR4.4.1. Removal1. Remove hood (see HOOD Removal).2. Remove canopy cover (see CANOPY COVER Removal).3. Remove the motor enclosure from the motor.4. Remove white wire and black wire terminal from the motor.4.4.2. Replacement1. Attach white wire and black wire terminals to the new motor.2. Replace the enclosure on the motor.3. Place new motor in canister base4 SERVICE PROCEDURES - CANISTER14MC-CG902-00