Panasonic MC-UG614 Operating Instructions Manual

Also see for MC-UG614: Operating instructions

Panasonic MC-UG614 Operating Instructions Manual Manual pdf 14 page image

-14-D) EXHAUST FILTER REPLACEMENTThe HEPA exhaust filter must be replaced whendirty. It should be replaced regularly depending onuse conditions. The filter CANNOT be washed as itwill lose its dust trapping ability.NOTE: See VACUUM CLEANERCONSUMABLES/ACCESSORIES (page 21) for theexhaust filter number.Remove exhaust filter cover by pressing the releasetab on the cover and rotating out from vacuumcleaner.PressFilterCoverReleaseTabExhaustFilterAIRFLOWPlace Seal SideAgainst VacuumCleaner BodyExhaustFilter Cover121211Remove the filter cartridge from cover.Place new filter cartridge into cover making sure thatairflow arrow on side of cartridge points into cover.Place foam seal of filter against the vacuum cleanerbody.Replace the exhaust filter cover by placing bottomtabs in slots and rotating in until cover snaps intoplace.E) SECONDARY FILTER CLEANINGWARNINGElectrical Shock HazardUnplug mains lead from electrical socket. Do notoperate the vacuum cleaner without thesecondary filter. Be sure the filter is dry andproperly installed to prevent motor failure and/orelectrical shock.SecondaryFilterDust BagRemoved For ClaritySECONDARY FILTERCheck secondary filter frequently and clean whendirty.If the secondary filter, located in the bottom of the dustbag chamber, is dirty, remove it by pulling forward outfrom under the ribs.Wash the foam filter in warm soapy water, rinse and drythoroughly by squeezing the filter in your hand andletting it air dry.DO NOT wash in the dishwasher.DO NOT install damp.DO NOT use vacuum cleaner without secondary filterand dust bag.Replace the secondary filter by sliding it back into placeunder the ribs in the dust bag chamber.11