Panasonic MINAS-BL GU series Technical Instructions

Also see for MINAS-BL GU series: Operating instructions

26 27Test run3 With Console ADirectionselectorswitchRUN/STOPswitchConsole Aconnectioncable (option)Speed potentiometer Power LEDRUNswitchRotatedirectionselectorswitchI1 inputenabledswitchConsole A(option)Set the RUN switch on the front panel to “RUN”, the rotate direction selector switch to“CCW”, and the I1 input enable switch (SW3) on the back of the product to “ON". Changeparameter 31 from “Vol - F” to “Vol - A” using Digital key pad or PANATERM for BL.To start the motor, set RUN/STOP switch to RUN position, and to stop the motor, set theswitch back to STOP position.Rotating direction can be switched from the direction selector switch on the side ofConsole A.If the rotation direction is reversed while the motor in the RUN mode, the rapid directionalswitching can cause tripping due to the inertia of load.Rotation speed can be adjusted by the speed potentiometer.Turn off power when the motor is to be stopped for a long time.■ AttentionWhen power is turned off with RUN/STOP switch in RUN position, and turnedon again, the motor will start again, which is dangerous. When turning on pow-er, always make sure that the switch is in STOP position.• When gear head is incorporated, the rotation direction of motor and that of gearoutput shaft are reversed for some gear reduction ratio. Please refer to the table of thepermissible torque (P.28).• For connection to Consol A, use optional Consol A connecting cable. (option: P.74)• The procedure descried above is for operation according to factory default. Differentprocedure is required if internal parameters have been changed by using the Digitalkey pad or PANATERM for BL.I/O connector sideTerminal No.TerminalsymbolLead color ofa cableConsole A sideterminal No.1 I 1 Brown 12 I 2 Red 23 I 3 —4 I 4 —5 I 5 —6 COM Orange 37 FIN Yellow 48 +5V Green 59 01 —10 02 —4 Digital key padPlease refer toTest run (Digital key pad) (P.41).Digital key pad