Panasonic NN-T695 Service Manual

Also see for INVERTER NN-H665: Operating instructions Instrucciones de operación Operating instructions Operating instructions User manual

Contents

4.6. Turntable motor1. Remove the motor cover by cutting, at the locationsindicated by the arrows, with a cutter.NOTE:After removing the motor cover, be sure that cutportions are properly trimmed or bent to the insideso that no sharp edges will be exposed to outside.2. Disconnect 2 lead wires connected to the turntable motor.3. Remove the turntable motor by removing screw.NOTE:After replacing the new turntable motor andreconnecting the two lead wires, reinstall the motorcover by rotating it 180, tucking the tabs into thebase in the 2 provided slots, then screw the singletab to the base usinga 4mm × 6mm screw.4.7. Steam sensor1. Disconnect connector CN2 from digital programmer circuitboard.2. Disengage catch hooks on sensor cover C from orifice.3. Remove steam sensor from orifice.NOTE:When installing the steam sensor, make sure thatthe direction of steam sensor is as shown in figure.14NN-T695 NN-T685SF