Panasonic NV-GS11 Operating Instructions Manual

Also see for NV-GS 8: Operating instructions

Contents

Others-53-≥If sea water splashes onto the Movie Camera,wet a soft cloth with tap water, wring it well, anduse it to wipe the camera body carefully. Then,wipe it again thoroughly with a soft dry cloth.Keep the Movie Camera away frommagnetized equipment (such as a microwaveoven, TV, video game equipment, etc.).≥If you use the Movie Camera on or near a TV,images or sounds may be disturbed due toelectromagnetic wave radiation.≥Do not use near cell phone because doing somay cause noise to adversely affect the pictureand sound.≥Recordings on the tape may be damaged, orimages may be distorted, by strong magneticfields created by speakers or large motors.≥Electromagnetic wave radiation generated by amicroprocessor may adversely affect the MovieCamera, causing the disturbance of images andsounds.≥If the Movie Camera is affected by magneticallycharged equipment and does not functionproperly, turn off the Movie Camera power anddetach the Battery or AC Adaptor and thenconnect the Battery or AC Adaptor again.Thereafter, turn on the Movie Camera power.Do not use your Movie Camera near radiotransmitters or high-voltage cables.≥If you record pictures near radio transmitters orhigh-voltage cables, recorded images or soundsmay be adversely affected.Do not use this Movie Camera for surveillancepurposes or other business use.≥If you use the Movie Camera for a long period oftime, the internal temperature increases and,consequently, this may cause malfunction.≥This Movie Camera is not intended for businessuse.When you use your Movie Camera on a beachor similar place, do not let sand or fine dustget into the Movie Camera.≥Sand or dust may damage the Movie Camera orCassette. (Care should be taken when insertingand removing the Cassette.)Do not spray insecticides or volatilechemicals onto the Movie Camera.≥If the Movie Camera is sprayed with suchchemicals, the camera body may be deformedand the surface finish may peel off.≥Do not keep rubber or plastic products incontact with the Movie Camera for a long periodof time.Do not use benzine, thinner or alcohol forcleaning the Movie Camera.≥The camera body may be deformed and thesurface finish may peel off.≥Before cleaning, detach the Battery or pull outthe AC Mains Lead from the AC mains socket.≥Wipe the Movie Camera with a soft dry cloth. Toremove stubborn stains, wipe with a cloth that issoaked in a detergent diluted with water andafterwards finish wiping with a dry cloth.≥For storing or transporting the Movie Camera,place it in a bag or case lined with soft pads soas to prevent the coating on the camera bodyfrom being worn.After use, be sure to take the Cassette out anddetach the Battery from the Movie Camera orpull out the AC Mains Lead from AC mainssocket.≥If the Cassette is left in the Movie Camera, thetape sags and deteriorates.≥If the Battery is left on the Movie Camera for along time, the voltage drops excessively, andthe Battery will not function even after it isrecharged.ª About AC Adaptor≥If the temperature of the Battery is extremelyhigh or extremely low, the [CHARGE] Lampmay continue flashing, and the Battery may notbe charged. After the temperature of the Batteryhas decreased or increased sufficiently,charging starts automatically. If the [CHARGE]Lamp continues to flash even after the Batterytemperature has decreased or increasedsufficiently, the Battery or AC Adaptor may befaulty. In this case, please contact a dealer.≥If the Battery is warm, charging takes a longertime than normal.≥If you use the AC Adaptor near a radio, radioreception may be disturbed. Keep the ACAdaptor 1 metre or more away from radio.≥When using the AC Adaptor, it may generatewhirring sounds. However, this is normal.≥After use, be sure to pull out the AC Mains Leadfrom the AC mains socket. (If they are leftconnected, a minute amount of current isconsumed.)≥Keep the electrodes of the AC Adaptor andBattery always clean.ª CondensationIf you turn the Movie Camera on whencondensation occurs on the head or the tape,Condensation Indication [3DEW] (yellow or red)blinks on the Viewfinder or the LCD monitor andthe messages [DEW DETECT] or [EJECT TAPE](only when the tape is inserted) appear. In thiscase, follow the procedure below.Blink in yellow:Dews are slightly adhering on the head or thetape.