Panasonic NV-GS33GC Operating Instructions Manual

Contents

Before Use-47-Setup on the Movie Camera:Set [REMOTE] on the [INITIAL] Sub-Menu to thedesired Remote Controller Mode. (-52-)Setup on the Remote Controller:[VCR1]:Press the [D] Button and [∫] Buttonsimultaneously. 1[VCR2]:Press the [E] Button and [∫] Buttonsimultaneously. 2≥When the battery in the Remote Controller isreplaced, the mode is automatically reset to[VCR1] Mode.Power Supplyª Using the AC Adaptor1 Connect the DC Input Lead to the MovieCamera.2 Connect the DC Input Lead to the ACAdaptor.3 Connect the AC Mains Lead to the ACAdaptor and the AC mains socket.≥The AC Mains Lead’s outlet plug does not fitentirely into the AC Adaptor socket. A gap willremain as shown 1.≥Before connecting or disconnecting thepower supply, set the [OFF/ON] Switch onthe Movie Camera to [OFF] and make surethat Power Lamp is not lit.ª Using the BatteryBefore use, fully charge the Battery.≥We recommend using Panasonic’s Battery.≥We cannot guarantee the quality of this MovieCamera when batteries of other companies areused.INDEX INDEXSELECTSTOPK L∫STILL ADVTWPAUSE STILL ADV6 1 5;E DP.B. ZOOM2 111 Attach the Battery to the AC Adaptor andcharge it.≥Since the Battery will not be charged whenthe DC Input Lead is connected to the ACAdaptor, disconnect it from the AC Adaptor.≥The [CHARGE] Lamp lights up, and chargingstarts.≥When the [CHARGE] Lamp goes off,charging is completed.≥When charging the overdischarged battery,the [CHARGE] lamp blinks at first, but thebattery is charged normally. When thetemperature of the battery is too high or low,the [CHARGE] lamp blinks and the chargingtime becomes longer than usual.2 Attach the charged Battery to the MovieCamera.Disconnecting the Power SourceSet the [OFF/ON] Switch (42) to [OFF] and, whilepressing the [PUSH BATT] Button (47), slide theBattery or DC Input Lead upward to disconnect it.≥For other notes concerning this item, see -76-.PUSHBATTONOFF(47)(42)