Before Use-8-≥When the battery in the Remote Controller is replaced, themode is automatically reset to [VCR1] Mode.Power Supplyª Using the AC Adaptor1 Connect the DC Input Lead to the Movie Camera.2 Connect the DC Input Lead to the AC Adaptor.3 Connect the AC Mains Lead to the AC Adaptor and theAC mains socket.≥The AC Mains Lead’s outlet plug does not fit entirely intothe AC Adaptor socket. A gap will remain as shown 1.≥Before connecting or disconnecting the power supply,set the [OFF/ON/MODE] Switch on the Movie Camera to[OFF] and make sure that [CAMERA/VCR/CARD P.B]Lamps are not lit.ª Using the BatteryBefore use, fully charge the Battery.1 Attach the Battery to the AC Adaptor and charge it.≥Since the Battery will not be charged when the DC InputLead is connected to the AC Adaptor, disconnect it fromthe AC Adaptor.≥After the [POWER] Lamp has lighted, the [CHARGE]Lamp flashes.2 When the [100%] Lamp 1 on the AC Adaptor islighted, charging is finished.≥When the [QUICK] Lamp 2 is lighted, approximately50 minutes of continuous recording is possible.≥The [QUICK] Lamp flashes and then remains lighted onlywhen charging a quick-charge type battery.3 Attach the charged Battery to the Movie Camera.1QUICK 100%CHARGEPOWER12Disconnecting the Power SourceSet the [OFF/ON/MODE] Switch (33) to [OFF] and, whilepressing the [PUSH BATT] Button (50), slide the Battery orDC Input Lead upward to disconnect it.ª Using the Car Battery ChargerIf you use the Car Battery Charger (VW-KBD2E; optional),you can supply power to the Movie Camera and charge thebattery inside your car. For further information, refer to theinstruction manual of the Car Battery Charger.Be sure to start the car engine before you connect the CarBattery Charger, otherwise the fuse may blow.≥For other notes concerning this item, see -42-.Charging Time and Available Recording TimeA Charging TimeB Maximum Continuous Recording TimeC Intermittent Recording Time(Intermittent Recording Time is the available recording timewith repeated recording and stopping actions.)“1h10min.” indicates 1 hour and 10 minutes.≥Battery VSB0419 is supplied.≥The times shown in the table are approximate times. Thenumbers in parentheses indicate the recording time whenthe LCD Monitor is used. In actual use, the availablerecording time may be shorter.≥The times shown in the table are for continuous recordingat a temperature of 20oC and humidity of 60%. If theBattery is charged at a higher or lower temperature, thecharging time may be longer.Lens Cap and Grip Beltª Attach the Lens CapTo protect the Lens surface, attach the Lens Cap.1 Pass the end of the Lens Cap String through the LensCap String holder.CGP-D14SCGP-D210A 1h30min.B 2h.(1h40min.)C 1h.(50min.)CGR-D16SCGR-D220VSB0419A 1h10min.B 2h20min.(2h.)C 1h10min.(1h.)CGP-D28SCGP-D320A 2h.B 4h5min.(3h25min.)C 2h5min.(1h45min.)CGR-D53SCGR-D815A 4h30min.B 7h40min.(6h25min.)C 3h50min.(3h15min.)CGA-D54S A 3h.B 7h55min.(6h35min.)C 4h.(3h20min.)(50)(33)PUSHBATTOFFONMODE