-20-ENGLISHSupplying Power with the BatteryCharge the Battery before using it.1 Attach the Battery.≥Align the Battery with line 1 and push it in thedirection of the arrow while holding it down.≥When charging, do not connect the DC Input Lead tothe AC Adaptor.2 Connect the AC Mains Lead to the AC Adaptorand an AC mains socket.≥The [POWER] Lamp 2 and the [CHARGE] Lamp 3light and charging starts.≥If the [CHARGE] Lamp 3 does not light even thoughthe Battery is attached, remove the Battery and thenre-attach it.3 Remove the Battery by sliding it in theopposite direction of Step 1 above.4 Insert the Battery with its top (so that the arrowpoints upward) into the top Battery Holder andpress the bottom of it toward the MovieCamera until it locks with a click.Removing the Battery from the Movie CameraHold the Battery firmly to prevent it from dropping and pull itoff while sliding the [2BATTERY EJECT] Lever 4 in thedirection of the arrow.≥Before removing the Battery, set the [CAMERA/OFF/VCR]Switch to [OFF].∫ Charging Lamp [CHARGE]Lit: During chargingOff: The Battery is fully charged.≥When first charging a Battery that is completely dischargedas a result of being in storage for an extended period oftime, etc., the [POWER] Lamp and the [CHARGE] Lampboth flash.≥Charge the Battery at a room temperature between 10oCand 30oC.≥During recording or charging, the Battery becomes warm.However, this is normal.≥To ensure precise indication of the remaining battery power,always use a fully charged Battery when attaching a Battery.422 11343 ! !"#$%&'(!)1 !"≥ !"# 1 !"#$%&'()*+,- !"≥ !"#$%&'()*+,-'./01/22 !"#$%&' (&)* !"+,-≥ xmltboz ! 2 x`e^odbz ! 3 !"#$%≥ !"#$%&'()&*x`e^odbz 3 !"#$%&'()*+,-.3 !" N !"#$%&'#()*+,4 !"#$%&'( )*!"# !" !"#$%&' !"#$ !"#$%&'( !"#$%&'()*%+,-./012x2 _^qqbovbgb`qz 4 !"#$%≥ !"#$%&x`^jbo^LlccLs`oz !"xlccz∫ !"x`e^odbz !"#$ !"#$%!&≥ !"#$%&'()*+&,-./012'34'xmltbozx`e^odbz !"#≥ !"#$%&' NM–PM≥ !"#$%#&'()%*+,-./0≥ !"#$% &'()*'+,-./0'(1.23 !"#$#%&