ing the Power ON and OFFAlways be sure to follow the procedure given below to turn the projection display power ON and OFF.• The lamp cooling fan will continue to operate for approximately 1 minute after the power is turned off, At the same time, thePOWER indicator will blink Red,Do not disconnect the power cord from the outlet and do not open the circuit breaker (unless necessary)while the cooling fan is still operating. Do not disconnect the power cord from the power outlet while thepower indicator blinks Red.POWER button/POWER indicatorTV/VUDEOPower ONPress POWER on projection display or Remote Controlto turn power on,The Power indicator blinks Green for about 10 secondsand then turns solid Green.Power OFFPress POWER on projection display or Remote Controlto turn power offPower shuts off after a Black Screen is displayed for afew seconds.Note:• if POWER is pressed during the Black Screen display, Poweris turned back on.The Power indicator blinks Red for about 1 minute andthen turns solid Red.Note:• When the AC Cord is unplugged, the internal cooling fan stops operating. In this case, the lamp \,viii be insufficiently cooled andwill take a while to turn ON again.The Po'a er IndicatorLED ACTIONRed Power - OFF (Standby mode)Red blink Power - OFF (Now cooling)Green Power - ONGreen blink Power- ON (Preparing to light lamp)Notes:• If the POWER button is accidentally turned off during use, after power is turned back on, it may take a short period before thelamp automatically comes on.• After the unit is turned on, maximum picture brightness will be achieved in 5-10 minutes. This is normal.22