Panasonic PT-47WXD64 Operating Instructions Manual

Contents

Panasonic PT-47WXD64 Operating Instructions Manual Manual pdf 20 page image

18 zREMOTE C ONTROL O PERATIONENGLISHProgramming The RemoteThe Universal Remote Control can be programmed tooperate many manufacturers’ components, using thecomponent function buttons for VCR, DVD, DBS, RCVR orAUX. Follow the procedures for programming your RemoteControl with or without a code for the component.Note: Determine the manufacturer of the component and lookin the table for the code (found on page 19).Procedure1. Confirm that the external component is plugged andoperating.2. Turn the component off.3. Press and together, for at least 5seconds. After 5 seconds, the illuminated mode(component) buttons will begin to flash. Release the OKand POWER buttons.4. Press appropriate component button on the RemoteControl VCR, DVD, DBS, RCVR, CBL or AUX (PVR orVCR2). The component button will illuminate steadilyand all others will go out.5. Enter the 3-digit component code using the RemoteControl numeric keypad (0 ~ 9 buttons). The componentbutton will blink twice.6. Press the Remote Control to test the component.If the procedure was successful, the component willturn on and the component key will blink twice and thengo out.Note: If the component does not operate with the RemoteControl, repeat steps 3 through 6 using another code.(Some brands have multiple codes). If an incorrect codeis entered, or if the procedure takes longer than 30seconds, the programming will fail.Programming Without A CodeThis procedure searches all codes and is called the“sequence method.”1. Confirm that the external component is plugged in andon.2. Turn the component off.3. Press and together, for at least 5seconds. After 5 seconds, the illuminated mode(component) buttons will begin to flash. Release the OKand POWER buttons.4. Press appropriate component button on the RemoteControl.5. Press the button to set the remote control into thestep and set mode.6. Point the remote control towards the component.7. Press VOL X (the mode key will blink three times), thenpress the Remote Control to test the component.Continue this process until the proper code is found. Ifthe procedure was successful, the component will turnon.Note: Each time you press the VOLX button, make sure thatthe component key blinks twice before pressing thePOWER button.8. Once the device responds, press to store thecode. The mode (component) button will blink twice.Note: It may take many attempts before the correct codeis found. If you miss a code, press WVOL, then press thebutton to test the component.Component CodesThe Universal Remote Control is capable of operatingmany component brands after entering a code. Somecomponents may not operate because the codes are notavailable due to limited memory. The Universal RemoteControl does not control all features found in each model.Device Operates DefaultTV TV (Panasonic Only) Panasonic CodeVCR VCR (Preset) Panasonic CodeDVD/CD DVD and CD (Preset) Panasonic CodeDBS DBS STB & CBL STB (Preset) Panasonic DBS CodeRCVR Audio Receiver (Preset) Panasonic RCVR CodeCBL Cable (Preset) Panasonic CABLECodeAUX Personal Video Recorders,Cassette and VCR2Panasonic PersonalVideo Recorder CodeOKPOWERPOWEROKPOWERWrite the code numbers from tables in this space.This will serve as a reference if you need to programyour Remote Control.VCR DVD DVD (CD)DBS RECEIVER CABLEAUX (PVR) AUX (VCR2)POWERPOWEROKPOWER