Adjusting the picture to the desired settingYou can adjust the picture settings for any of the input signal sources selected according to the procedure on page 18.The items which can be adjusted vary depending on the type of input signal. The adjustment procedure belowdescribes the on-screen displays when a signal is being input to the S-VIDEO IN terminal or the VIDEO IN terminal.Adjustment procedure 1. Press the MENU button to display the MENU screen.2. Press the “ ” and “ ” buttons to select “PICTURE”.3.4.5.6.Press the “<”and “>” buttons to display the PICTURE screen.Press the “ ”and “ ” buttons to select “COLOR”.NOTE:If the STD (Standard) button is pressed while the PICTURE screen at right isbeing displayed, the letters “STD” will be displayed in yellow in the top-rightcorner of the screen and all settings other than the TV-SYSTEM setting will bereset to the factory pre-settings. Furthermore, the values and bar displays foritems which have returned to the factory pre-settings will be displayed in yellow.Press the “<” and “>” buttons to display the COLOR individual adjustment screen.Continue pressing the “<” and “>” buttons to adjust the color. The current settingwill be displayed on the screen by numerals and a bar.The adjustment operation and the changes made will vary depending on whichadjustment item is selected. Refer to the table below for details.Adjustment function displayNumeric adjustment level display Bar displayAdjustment Item Button Adjustment Details Adjustment Range RemarksPress the “>” button. The color becomes darker. Max. value 63COLOR Press the “<” button. The color becomes lighter. Min. value 0 S-VIDEO/VIDEO onlyTINTBRIGHTPress the “>” button. Flesh tones become greenish. Max. value 63 NTSC, NTSC 4.43 (S-Press the “<” button. Flesh tones become reddish. Min. value 0 VIDEO/VIDEO)onlyPress the “>” button. The screen becomes brighter. Max. value 63Press the “<” button. The screen becomes darker. Min. value 0CONTRASTPress the “>” button. The screen becomes brighterand the picture becomes darker. Max. value 63Press the “<” button. The screen becomes darker and Min. value 0the picture becomes lighter.SHARPNESS Press the “>” button. The picture quality becomes sharper. Max. value 63Press the “<” button. The picture quality becomes softer. Min. value 0 S-VIDEO/VIDEO onlyNOTE:If approximately five seconds pass without any buttons being pressed while an individual adjustment screen isbeing displayed, the display will return to the PICTURE screen.Press the MENU button to return to the PICTURE screen or to clear the MENU screen.If the STD (Standard) button is pressed while one of the individual adjustment screens is being displayed, thevalue and the bar display will be appeared in yellow and only the item displayed will be reset to the factory pre-setting.Refer to page 20 for details on the TV-SYSTEM setting which is displayed in the PICTURE screen, and to thefollowing page for details on the W-BAL R/G/B setting which is displayed when RGB signals are being input.Furthermore, refer to page 19 for details on the SIGNAL MODE setting when RGB signals are being input.If a PAL or SECAM signal is being input, the TINT item will not appear on the screen.22
