Panasonic PT-L6510U Operating Instructions Manual

Also see for PT-L6510U: Specifications Specifications Specifications

Contents

Panasonic PT-L6510U Operating Instructions Manual Manual pdf 36 page image

36Deleting User Mode(e.g. Deleting the data of USER1)1. Choose “USER MODE” on “OPTION2” and pressthe “ENTER” button.2. Choose “DELETE” using the or buttons.3. Choose the address (“USER1”) you want to deletedata from using the or buttons and press the“ENTER” button.4. After recorgnizing the flashing of the addressdisplay, press the “ENTER” button again to deletethe data of the address.Registering/Deleting/Displaying User Mode(For RGB/YP BP R signals only)Once adjustment settings are registered with UserMode, they are automatically loaded each time theprojector is powered up. It is not necessary to readjustsettings at every power on.Registering User Mode(e.g. Registering positioning data with “USER1”)1. Apply an input signal you want to register, andthen adjust the picture position, size, and others.2. Choose “USER MODE” on “OPTION2” and pressthe “ENTER” button.3. Choose “USER1” using the or buttons andpress the “ENTER” button.4. After recognizing the flashing of the “USER1”address display, press the “ENTER” button again.5. The above adjusted settings has been registeredwith “USER1”. Similarly you can also registersettings with “USER2” or “USER3”.SETTING UNIT IDUNIT ID is used to set projector IDs when the userwishes to control two or more projectors eithersimultaneously or separately.“ALL”: The projectors can be simultaneouslycontrolled from any remote control regardlessof their ID settings.“1”: The projector can be controlled from the remotecontrol with its projector ID set to “1”.“2”: The projector can be controlled from the remotecontrol with its projector ID set to “2”.“3”: The projector can be controlled from the remotecontrol with its projector ID set to “3”.Note• Unit ID is set to “ALL” by default. Hence IDnumber need not be set when only oneprojector is used.• If the projectors are given ID numbers, theirremote controls must be assigned the sameID numbers, respectively.• If the unit IDs of two or more projectors areset to “ALL”, the user will not be able tocontrol them separately.• The projector can be turned ON/OFF fromthe remote control only if the projector ID isset in the remote control. For the details ofprojector ID setting, see page 15.SET ID ALL123USER MODEENTRY USER1SELECT ADJ ESCUSER MODEENTRY USER1DELETE USER1SELECT ADJ ESCOPTION 2 settingsDisplaying User ModeThe User Mode can be displayed by following thesteps described in “SIGNAL MODE” on page 31.Note• The user address has “USER1” to “USER3”.