10Using WebBrowser (cont.)Enabling JavaScriptIf JavaScript has been set to disable, enable it.Open window.1 Click [Start] → [Control Panel] → [Network and Internet Connections] → [Internet Option].Click the [Security] tab and set the security level to [Default Level], or select [Custom2 Level] and check the [Enable] checkbox under [Active scripting].Accessing from the WebBrowserStart up the WebBrowser, and enter the IP address set to the projector.1 The WebBrowser starts up and the authentication window appears.http://10.69.104.56Enter the User name and the Password.2Click [OK].3 window appears. (11 page)The default user name and password settings are as follows:• User name: user1 (with user authority) / admin1 (administrator authority)Password: panasonic (lower case)Administrator authority has full access to the all features. User authority has access to “Status”, “Projector control” and “Change• password”. (User authority has no access to “Detailed set up”.)Password used in this page is for accessing the web control window.• (See page 16)The system locks for several minutes if an incorrect password is entered three times in succession.• If you initialize the network settings, the password is reset to “panasonic”. Change the password to an appropriate one.• Make sure the password is as hard to guess as possible.• Change the password periodically.• If you have forgotten the password, perform [INITIALIZE] in the projector• ’s NETWORK menu (See page 8), and set a new onein the “Change password” window of your WebBrowser. (See page 16)Panasonic Corporation and its affiliated companies never directly ask customers for their password.• Do not give out your password even if directly asked by a third-party representing themselves as Panasonic Corporation.The Top window may not appear depending on the WebBrowser. In this case start up WebBrowser again, or press the [Ctrl] + [R]• keys for example to update the screen.Connection cannot be made while the WebBrowser is set to dial-up network. Cancel the dial-up network setting.• It may take some moments for WebBrowser to start up.•
