Panasonic PT-LB50NTU Operating Instructions Manual

Also see for PTLB50U - XGA LCD Projector: Specifications

Contents

8-E NGLISHAlways disconnect all cables before moving the projector.B Moving the projector with cables still attached can damage the cables,which could cause fire or electric shocks to occur.Do not place any heavy objects on top of the projector.B Failure to observe this may cause the projector to become unbalancedand fall, which could result in damage or injury.Do not short-circuit, heat or disassemble the batteries or place theminto water or fire.B Failure to observe this may cause the batteries to overheat, leak, explodeor catch fire, and burns or other injury may result.When inserting the batteries, make sure the polarities (+ and -) arecorrect.B If the batteries are inserted incorrectly, they may explode or leak, and fire, injuryor contamination of the battery compartment and surrounding area may result.Use only the specified batteries.B If incorrect batteries are used, they may explode or leak, and fire, injury orcontamination of the battery compartment and surrounding area may result.Do not mix old and new batteries.B If the batteries are inserted incorrectly, they may explode or leak, and fire,injury or contamination of the battery compartment and surrounding areamay result.Do not put your weight on this projector.B You could fall or the projector could break, and injury may result.B Be especially careful not to let young children stand or sit on the projector.If not using the projector for an extended period of time, disconnect thepower cord plug from the wall outlet.B If dust builds up on the power cord plug, the resulting humidity maydamage the insulation, which could result in fire.B This projector continues to draw approximately 4 W of power even whenthe power is turned off.Disconnect the power cord plug from the wall outlet as a safetyprecaution before carrying out any cleaning.B Electric shocks can result if this is not done.If the lamp has broken, ventilate the room immediately. Do not touch orbring your face close to the broken pieces.B Failure to observe this may cause the user to absorb the gas which wasreleased when the lamp broke and which contains nearly the sameamount of mercury as fluorescent lamps, and the broken pieces maycause injury.B If you believe that you have absorbed the gas or that the gas has got intoyour eyes or mouth, seek medical advice immediately.B Ask your dealer to replace the lamp unit and check the inside of theprojector.