Panasonic PT PT-LB90NT Network Operation Manual

Also see for PT-LB90NT: Specification sheet Specifications

Contents

Panasonic PT PT-LB90NT Network Operation Manual Manual pdf 4 page image

4Wireless connection function of the projector uses radio waves in the 2.4 GHz band.A radio station license is not required, but be sure to read and fully understand the following items before use.Do not use near other wireless equipment.The following equipment may use radio waves in the same band as the projector.When the projector is used near these devices, radio wave interference may make communication impossible, or thecommunication speed may become slower.• Microwave ovens, etc.• Industrial, chemical and medical equipment, etc.• In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.• Designated low-power radio stationsIf at all possible, avoid the use of cellular phones, TV sets or radios near the projector.Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so there is no effect onwireless communication or the transmission and reception of these devices. However, radio waves from the projector may produceaudio or video noise.Wireless communication radio waves cannot penetrate steel reinforcements, metal, concrete,etc.Communication is possible through walls and floors made from materials such as wood and glass (except glass containingwire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.Avoid using the projector in locations prone to static electricity.If the projector is used in a location prone to static electricity, such as on a carpet, the wireless LAN or wired LAN connectionmay be lost.If this happens, eliminate the source of static electricity or electromagnetic noise and reconnect to the wireless LAN or wiredLAN.In rare cases static electricity or electromagnetic noise may make it impossible to establish a connection to the LAN.If this happens, press the power button on the remote control or on the projector to power off the projector temporarily.After the cooling fan stops operating (after the power monitor on the projector changes from orange to red), power on theprojector and reconnect to the LAN.Using the projector outside the countryIt is forbidden to take the projector outside the country or region where you purchased it, so use it only in the said country orregion. Also, note that depending on countries or regions there are restrictions on the channels and frequencies at which youcan use the wireless LAN.Notes on Using Wireless Connection