Chapter 4 Settings — [PROJECTOR SETUP] menu150 - ENGLISHf When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NOSIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to “NONE”.[REMOTE2 MODE]You can set the terminal.1) Press as to select [REMOTE2 MODE].2) Press qw to switch the item.f The items will switch each time you press the button.[DEFAULT] Uses pin assignment of the terminal in standard setting. (x page 222)[USER] Changes the setting of the terminal.f When [USER] is selected, proceed to Step 3).3) Press the button.4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.[FUNCTION BUTTON]Set the function of the button on the remote control.1) Press as to select [FUNCTION BUTTON].2) Press the button.f The [FUNCTION BUTTON] screen is displayed.3) Press as to select a function.[DISABLE] Disables the button.[P IN P] Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (x page 158)[SUB MEMORY] Displays the sub memory list. (x page 163)[SYSTEM SELECTOR]Switches the [SYSTEM SELECTOR] setting according to the input signal of the image beingprojected.f When the input signal is anything other than SDI1 input or SDI2 inputThe [PICTURE] menu → [SYSTEM SELECTOR] (x page 94)f When the input signal is SDI1 input or SDI2 inputg The [DISPLAY OPTION] menu → [SDI IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2] →[SYSTEM SELECTOR] (x page 125)g The [DISPLAY OPTION] menu → [SDI IN] → [DUAL LINK SETTING] → [SYSTEM SELECTOR](x page 125)[SYSTEM DAYLIGHT VIEW] Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 91)[FREEZE] Temporarily pauses the image. (x page 132)[WAVEFORM MONITOR] Displays the waveform of the input signal. (x page 132)[LENS MEMORY LOAD] Loads the registered lens memory. (x page 151)[LEFT/RIGHT SWAP] Switches the [LEFT/RIGHT SWAP] setting. (x page 109)[PROJECTION METHOD] Switches the [PROJECTION METHOD] setting. (x page 134)4) Press the button.[LENS CALIBRATION]Detect the lens shift limit value of the projector and set the home position and the ET-D75LE95 lens standardposition automatically.1) Press as to select [LENS CALIBRATION].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Select this item when anything other than the Fixed-focus Lens (Model No.: ET-D75LE95) is used.Move the lens to the home position after completing the calibration.
