Chapter 1 Preparation — About your projector28 - ENGLISHf Avoid contact with liquids or moisture.f Do not attempt to modify or disassemble the remote control.f Do not swing the remote control holding onto the strap when a strap is attached.f Observe the following instructions that are indicated on the caution label at the back of the remote control:g Do not use old battery with new one.g Do not use batteries other than the type specified.g Be sure the batteries are inserted properly.For other instructions, read the instructions related to batteries that are described in “Read this first!”.1.Do not use old battery with new one.2.Do not use batteries other than thetype specified.3.Be sure the batteries are inserted properly.Made in ChinaCaution label at the back of the remote controlNotef When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control ata distance approx. 30 m (98'5") or shorter from the remote control signal receiver. The remote control can control at angles of up to ±15°vertically and ±30° horizontally, but the effective control range may be reduced.f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Useit in a place distant from the light source.f The power indicator will blink if the projector receives a remote control signal.Projector body1 2 3 4 5 67 7118 10 8 8 9913 149 99 9 99 15912 9 916 179Front SideRearProjection direction1 Remote control signal receiver (front)2 Power indicator Indicates the status of the power.3 Light source indicator Indicates the status of light source 1.4 Light source indicator Indicates the status of light source 2.5 Temperature indicator Indicates the internal temperature status.6 Filter indicator Indicates the status of the air filter unit.7 Adjustable feetAdjusts the projection angle.8 Air intake port9 Screw holes for eyeboltsScrew diameter: M10, tapping depth inside the projector:35 mm (1-3/8")10 Air filter coverThe air filter unit is inside.
