16- ENGLISHPreparationAbout Your ProjectorRemote control(17)(16)(15)(14)(13)(12)(11)(18)(19)(1)(2)(4)(5)(6)(8)(7)(3)(9)(10)(1)Remote control signal emitter(2) buttonSwitches COMPUTER 1 or COMPUTER 2input. If either of the input is selected, press button will switch to the otherone.(3)<v/b>buttonTurns the projector on/off.(4) buttonDisplays [Lamp Power Mode] menu.(5) buttonTemporarily stops the image and mute thesound. Press again to return to previous state.(6)Turns the main menu on/off.(7) buttonDisplays [Source] menu. (Æpage 31)(8) buttonTemporarily mutes the sound.Press again to return to previous state.(9) buttonAdjusts the image to compensate for distortioncaused by tilting the projector.(10) buttonMomentarily turns off/on the audio and video.Press again to return to previous state.(11) buttonSwitches to HDMI source.(12) buttonDisplays [Information] menu.(13) Switches to Video source.(14) buttonAdjusts the image to compensate for distortioncaused by tilting the projector.(15) buttonSelects the color mode among Dynamic, PC,Movie, Game and User.(16) ▲▼◄► buttonsUsesto operate menu.(17) buttonAutomatically synchronize the projector to theinput source.(18) buttonSelects [Aspect Ratio] in [Screen].(19) buttonsIncreases/decreases speaker volume.AttentionDo not drop the remote control.zAvoid contact with liquids.zDo not attempt to modify or disassemble the remotezcontrol.NoteThe operation may not optimize the imagezposition or the resolution, depending on the input signalformat or the image contents. In this case, switch to adifferent image and execute again.When pointing the remote control directly toward thezprojector (Remote control signal receiver), operatingrange for the remote control is within 8 m (26.25 ft). Also,operation range available for four directions (up, down,left, right to the projector) is ± 30° and the operationdistance may become short.If there are any obstacles between the remote controlzand the remote control signal receiver, the remote controlmay not operate correctly.You can operate the projector by reflecting the remotezcontrol signal on the screen. The operating range maydiffer due to the loss of light caused by the properties ofthe screen.When the remote control signal receiver is lit with azfluorescent light or other strong light source, the projectormay become inoperative. Set the projector as far fromthe luminous source as possible.You can operate all of the functions of the projector viazthe remote control. Make sure not to lose the remotecontrol.Before using the remote control for the first time, removezthe transparent insulation sheet.0Q2/L&(//92/76-$3$1+&5Transparent insulationsheet
