| 
S P E C F I L EPT-VW431DLCD ProjectorAs of September 2012SFL12M0151 2 / 1 3Status request commandsCommand Description CallbackQPW *Q$S *QINQAVQPMQFZQ$LQSHStandby power statusLamp statusInput signal statusVolume adjustment valuePicture mode statusFreeze statusLamp run timeAV mute function statusStandardDynamicCinemaRealBlackboardColorboardImage 1Image 2Image 3Image 4 condition> condition> signal>STDDYNCINREABBDCBDIM1IM2IM3IM4* These commands are effective when the standby mode is set to eco. (Other commands are not effective.)Command exampleTo set the volume to +30, send the command as shown below.STX AVL : 30 ETXStart Command Parameter EndNOTE: When sending commands without parameters, a colon (:) is not necessary.Parameter formatParameter format Size (Byte) Definition on> signal> condition> condition>3 (1 or 2 bytes alsopossible whenunder control)137314Decimal without signs: 0 to 999 (000, 001, 002...999)Decimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)Callback from the projector is 3 Byte.0 = off, 1 = onDL1 = DIGITAL LINK, HD1 = HDMI, RG1 = computer 1 (RGB),RG2 = computer 2 (RGB), VID = video, SVD = S-Video,SCT=Computer 1 (Scart)When Digital interface box is connected to DIGITAL LINK terminal, andINPUT is selected to DIGITAL LINK terminal and Digital interface boxat the same time:DL1: HD1 = HDMI 1DL1: HD2 = HDMI 2DL1: PC1 = Computer 1 (RGB)DL1: PC2 = Computer 2 (RGB)DL1: VID = VideoDL1: SVD = S-Video000 = power off (standby mode off), 001 = power on (standby mode on)0 = standby, 1 = lamp on under control, 2 = lamp on,3 = lamp off under controlDecimal without signs: 0000 – 9999 hours |
