Panasonic Palmcorder PV-GS200 Operating Instructions Manual

Also see for Palmcorder PV-GS120: Operating instructions Operating instructions

Contents

Panasonic Palmcorder PV-GS200 Operating Instructions Manual Manual pdf 16 page image

Before UseSelecting Remote Controller ModesWhen 2 Camcorders are used simultaneously,they can be operated individually by selectingdifferent Remote Controller Modes.• If the Remote Controller Mode of theCamcorder and that of the Remote Controllerdo not match, [REMOTE] Indication isdisp{ayed.Setup on the Camcorder."Set [REMOTE] on the [INITIAL] Sub-Menu to thedesired Remote Controller Mode. (-2J-)Setup on the Remote Controller:[VCR1]: Press the [1_-]Button and [11] Buttonsimultaneously, 0[VCR21: Press the [-,I]Buttonand [11]Buttonsimultaneously. 0• When the battery in the Remote Controller isreplaced, the mode is automat{cally reset to[VCR1] Mode._Supp/y ..............................................................• Using the AC Adaptor01 Connect the DO Cable to the Camcorder.2 Connect the DO Cable to the AC Adaptor.3 Connect the AC Cable to the AC Adaptorand the AC Jack.• The AC Cable's outlet plug does not fitentirely into the AC Adaptor jack. A gap willremain as shown O.• Before connecting or disconnecting thepower supply, set the [OFF/ON] Switch onthe Camcorder to [OFF] and make sure that[POWER] Lamp is not lit.• Using the BatteryBefore use, fully charge the Battery.• We recommend using a Panasonic Battery.• We cannot guarantee the quality of thisCamcorder when batteries from othercompanies are used.1 Attach the Battery to the AC Adaptor andcharge it.• Since the Battery will not be charged whenthe DC Cable is connected to the ACAdaptor, disconnect it from the AC Adaptor.• The [CHARGE] Lamp lights up, and chargingstarts.• When the [CHARGE] Lamp goes off,charging is completed.• When the battery is completely discharged,the [CHARGE] lamp blinks at first, but thebattery is charged normally. When thetemperature of the battery is too high or low,the [CHARGE] lamp blinks and the chargingtime becomes longer than usual.2 Attach the charged Battery to theCamcorder.Disconnecting the Power SourceSet the [OFF/ON] Switch i_ to [OFF] and, whilepressing the [PUSH BATT] Button i_, slide theBattery or DC Cable upward to disconnect it.• For other notes concerning this item, see *Tt*.-15-